answersLogoWhite

0


Best Answer

slave cylinder

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why won't my clutch pedal come back up after pressing it down?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is wrong if the clutch pedal does not come back up fully and gears stick?

You may need to adjust your clutch or replace your clutch.


Why does the brake light come on when engaging the clutch - it goes off as soon as I release the clutch. It doesn't come on when I brake...?

There is ( or should be ) a switch on your brake pedal lever that tells your brake lights to come on. Could this switch be incorrectly mounted on your clutch pedal instead? Do you have a switch on each pedal? If you do the one on your clutch is so the car won't start unless the clutch is depressed. It might have the wires reversed or the switches might both be mounted on the wrong pedal.


What can be the problems can not change gears or anything 2003 alero clutch goes to floor and stays?

broken clutch cable could also be a shot slave cylinder...this will cause the clutch pedal to not come back up.


How do you know if your clutch is bad on your 93 f-150 49 the pedal goes to the floor and doesn't come back up?

Sounds like you have broken the 'clutch return spring' in the transmission or if it's hydraulic you may be out of clutch fluid (leaking)


Where did the idiom put the pedal to the medal come from?

To my understanding, the saying is rightly "put the pedal to the metal", and would come from pressing a car's accelerator all the way down to the metal flooring. To my understanding, the saying is rightly "put the pedal to the metal", and would come from pressing a car's accelerator all the way down to the metal flooring.


1996 Chevrolet 3500 truck 454 engine and when I pull a trailer on the highway the clutch pedal gets a lot of slack in it but it will come back when I slow down to 50mph?

does the car seem to loose power when the pedal has slack in it. sounds like you have a worn out clutch that is slipping. this needs to be replaced or adjusted


The clutch pedal stays down after depressing it you have to use your foot to pull it back up you have adjusted the clutch cable with no luck The car is a 1998 Nissan 200SX SE?

Check for a spring at the very top of the pedal itself, running from the pedal above the pivot point to the firewall. The spring is likely to have come loose and be attached at one end or the other but not both.


How can you repair your clutch on your 1996 ford ranger the clutch came completely off the bracket?

I assume you mean the pedal came off. Did it break or did the retainer clip that holds the pedal on the shaft come off? It may just be a case of putting it back together and maybe a new C clip or cotter pin.


Why does the clutch pedal stick to the floor?

You've blown a clutch hose by the sound of it, or you've got a leak in the clutch master or slave cylinder. Either way, without clutch fluid, the clutch pedal wont come off the floor and the clutch will be disengaged. Any half decent mechanic should be able to figure out what the issue is without charging and arm and a leg.


How do you repair the clutch pedal on a Nissan Maxima 91 SE if it does not come back when you press it?

TAke it to a garage as there is a leak and it may need new parts. Bleeding the system is very hard also.


2002 Cadillac DTS won't come out of park?

Check the brake pedal sensor sounds like this is your problem assuming that you are pressing the pedal while trying to shift out of park


Why does the 93 VW Cabriolet internal brake light come on when engaging the clutch - it goes off as soon as you release the clutch and doesn't come on when braking?

Someone mounted the brake light switch on the wrong pedal?