0
On a 16 year old car, I would first replace very single vacuum hose under the hood. Replace them one at a time as to not get confused. If you notice the brakes are hard to push, suspect a busted brake booster diaphram. If you have not replace the plugs/plug wires, in the last 75,000 miles, replace them.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the mass air flow sensor on 91 Buick century?
Where is the MAF in 91 Buick century
What would cause a 91 Buick centrey to idle fine for 15 or 20 min and then kill of without any check engine or temp lights not modular or comp?
where is the Kill start button on a buick century 2003?
Where is the ecm located on a 91 Buick century 3.3?
i donnoe
How do you remove the interior door panel on a 91 Buick century?
Very Carefully
How do you install fuel pump on 91 buick century?
You must remove the fuel tank.
I have a 91 Buick Century When I try to accelerate it even if it is a little bit it shuts itself off and will start back up and other times wont it does this while going down the road what is cause?
The rev limiter would have cut in
91 buick skylark 3speed transmission wont shift out of low?
Check of change fluid and filter--if this doesn't help it may be time for a rebuild
What is the oil capacity for a 1990 Buick Century?
always look in your owners manual. but I've driven and maintained a 90 91 93 buick century. if 6 cylinder i would suggest 4.4 litres or oil and change the oil filter at every oil change.
What is the wheel stud thread size on a 91 buick century. putting after-market rims on and don't know what size lugs to buy?
12mm by 1.5
Why does your 91 Buick century idols high after replacing harmonic balancer?
sounds like you broke the crank sensor that is mounted right behind the balancer.
Will a 91 Buick Regal engine fit into a 91 Buick Park Avenue?
If they are the exact same engine (3800 tuned port injection) then yes.
How does the ignition cylinder come out on your 91 Buick century?
Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.
