answersLogoWhite

0


Best Answer

If you're fairly certain the compressor is properly charged and in good working order, then you must determine if your AC/Heater Control Panel is functioning properly by moving the thermostatic control knob back and forth from Hot to Cold and listening for the compressor to kick on. Often times when a new blower motor unit is installed, two identical wires (one wire goes to the Remote Trunk Unlock Button) get crossed and plugged to the wrong connectors which will blow the control panel each and every time; the Control Panel will then need to be replaced. Not sure if you can purchase a new/refurbished Control Panel, but they can possibly found on EBAY for $50-$120. So if your AC vents are blowing hot air no matter where the thermostat is set, then this is possibly your problem, considering your compressor is working properly.

Easy install, but make sure those two wires are in the proper order first.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would a 1991 Acura Legend ac still blow hot air after changing the compressor is it related to a head gasket leak?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Do you need a thermostat gasket or just a housing ring when changing thermostat for 91 acura legend?

You should use a thermostat gasket along with the thermostat housing ring. The gasket should be replaced every time the thermostat housing is opened.


How do you replace an Air compressor gasket?

There are many gaskets on any machine. Is this an electric compressor? Once you find what gasket it is specifically, you simply need to remove that part, and add a new gasket, then put the part back on...


When changing timing chain gasket on 350 Chevy do you have to change the pan gasket?

yes you have to change the pan gasket when doing the timing chain


How can pneumatic system trobleshoot?

Replace the rubber gasket. Inspection of air valves. Compressor control.


Does the timing belt have any factor of changing the head gasket?

no


How to Changing valve cover gasket 2000 catera?

To replace the valve cover, you will need to break the gasket and the o-rings. The gasket prevents oil from leaking.


Changing head gasket do you have to take rocker arms off?

yes


Does not changing the oil cause a blown head gasket?

That isn't likely. Most head gasket failures are caused by overheating. Not changing the oil will cause the motor to sludge up and increase the wear on the internal parts.


What is the main fuel pump gasket on a 2004 Ford Taurus?

To the best of my knowledge, there is only 1 gasket on the fuel pump.The fuel pump assembly sits in an opening in the top of the gas tank - and it's there you'll find a big fat gasket that overlaps the sheet metal opening.See "Related Questions" below for more about changing fuel pumps.


How do you replace an oil filter gasket in a 3.8 2001 Ford Windstar?

The oil filter gasket is built into the filter itself, so just by changing the filter, you always get the new gasket.


Cost of changing thermostat 1994 grand prix?

15.00. for gasket and thermostat


Do you have to have the transmission flushed at a dealer when changing the transmission fluid?

No, Fluid, filter, and gasket