CHECK YOUR TRANNY SHIFTER PLATE ON DRIVER SIDE PART OF THE TRANSMISSION , SEE IF IT LOOSE, THE LEVER IS CONECTED TO A BOLT THAT CONTROLS THE GEAR PISTON THAT SHIFTS GEARS , IF YOU CAN SHIFT THE GEARS BUT DONT HEAR A CLICK , THAT MEANS THE BOLT ON THE OPPOSITE SIDE OF THE SHIFTER PLATE ON THE INSIDE OF THE PAN IS LOOSE OR MAY HAVE COME OFF AND YOUR TRANNY WILL NOT SHIFT AND STAY IN PARK ......IF THAT HAPPENS , AND YOUR NOT HIP TO WORKING ON TRANNYS , BRING IT IN OR TOW IT, IF YOU DO UNDERSTAND SOMETHING ABOUT TRANNYS , DRAIN THE FLUID PULL THE PAN OFF AND YOU WILL SEE WHAT IM TALKING ABOUT ..HOPE I HELP ALITTLE IF THIS DOSENT EVEN PERTAIN TO YOUR QUESTION SORRY ABOUT WAISTIN YOUR TIME...
disconnect the trans cable at trans connection with someone on brake or apply the parking brake
There is no parking brake. You hold the tractor in place by putting it in park like a car with auto trans.
set the parking brake on put the trans into drive and while applying the brake set the rpm to its higher point the release
Yes but if it's not an auto you should have one so trans alone does not have to hold it if on an incline
If your parked on a hill it may do that. Next time set the parking brake before you put the trans in park.
Check for: low trans fluid parking brake engaged broken or dislodged axle shaft transmission problem
Parking brake applied or stuck on.Incorrect fluid level in trans. Transmission is bad.
Remove the side panel on the left front of the interior. The there is one bolt and one nut on the interior that you will remove. There are two nuts on the firewall underneath the brake booster that must be removed. After you remove, in total three nuts and one bolt, you can remove the parking brake assembly. Then just remove the cable. Done.
No, do not mix trans and brake fluids. The trans is dextron and the brake fluid is dot3.
Warm up your engine since transmission fluid expands when hot. Set the parking brake on a level surface and put the shifter in neutral. Then pull the trans dip stick with the engine running, the same as checking your oil.
Just pull the parking brake up one click. It won't engage the brake, but it bypasses the headlights.
The brake system uses brake fluid and the trans uses trans fluid.