most likely needs and oil change or you didn't reset the oil change light after you got an oil change. The truck has a standard that automatically cuts on the oil light either when the oil is low or you have driving a certain distant and not had an oil change. Also if you have had an oil change recently and didn't reset the oil indicator than it doesn't recognize that you did get an oil change. To reset oil indicator all you do is turn the key to the run position (two click, do not start truck) then pump the gas pedal all the way to the floor three times the oil light should flash then go off.
Probably a faulty ignition switch. learn more at www.trailvoy.com Trailblazer enthusiasts website.
What would cause the engine not to restart when hot Chevy Trailblazer 2007?
Yes
You have to open the rear hatch like you would to replace the reg. brake lights. Screws should be accessible once hatch is fully open.
There are a few good websites that sell Chevy Trailblazer parts. The most popular site would be Ebay.
Come to our Trailblazer enthusiasts forum and find your answer www.trailvoy.com
AnswerActually all you have to do is: ignition on - engine off - floor the gas pedal 3 times When you turn your ignition on (spot right before you would turn on the engine) push the gas pedal all the way to the floor and allow it to release each time. When that is complete turn your vehicle on. A 2005 Trailblazer will blink its change oil light a few times and then turn off completely. In your manual scratch out "take your car to the dealer" and write this down this procedure instead.
i dont know but would like to know!!!
That would be an XL, Same with the Envoy and Buick Raineer.
The battery in the remote needs to be replaced.
Huh? This would be the 5 cylinder engine? No # 6 spark plug? Or the V8? What year vehicle? Need more info, sorry
is it a push button if so it my be the motor on the transfer case i have a 93 ford that did the same thing it would be a place to look and its not hard to change