answersLogoWhite
Cars & Vehicles
Auto Parts and Repairs
Cadillac DeVille
Pollution

Why would a fuel injected car run a while then cut off especially if you try to give it gas after changing the motor?


Top Answer
User Avatar
Wiki User
2006-12-22 16:11:25
2006-12-22 16:11:25

Either the fuel filter is stopped up or the fuel pump has low preasure for some reason.

Related Questions

User Avatar

it would depend if the car is carburated, or fuel injected... if it is carburated it can flood the motor (if this happens just give it about 20 mins and try and start it again), if it is fuel injected nothing will happen.

User Avatar

Her incapacity while changing the oil in her car made the motor burn up. Incapacity describes the inability to do a certain task.

User Avatar

remove front cowling remove plug to motor. remove rod arm from motor. remove two bolts holding in on. while it is apart changing the wiper bushing may be a good idea. install in reverse.

User Avatar

You need to introduce a delay after changing a driver output line for a stepper motor because the stepper motor requires finite time to respond to the command to step. Hundreds, if not thousands, of instructions can be executed while the stepper motor completes its step.

User Avatar

check/clean the earth lead to the motor. it will be from neg side of battery to the motor. as at night with the light on it might be taken most of you earth to the motor that is worth a try


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.