0
tensioner wobble , check all pulleys for straightness and replace as need
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What would cause the serpentine belt of a 1999 Dodge Grand Caravan to keep slipping off the pulleys?
One of the pulleys is out of alignment,usually it is the tension pully. Replace it and problem will go away.
Why do socks keep slipping off?
because it had a bonner
Why would the serpentine belt on a 1994 Le Baron keep slipping off of the pulleys?
Assuming the tensioner is keeping the belt tight, you need to make sure all of the pulleys are still in a straight line. If a bearing has failed in a pulley the puley will "lean" causing the belt to run off the edge.
Why does the serpentine belt keep slipping off the 1995 gmc sierra pickup?
that truck has 4 belts that may fit. 2 belts with ac 2 belts without. you need a size 55
Replace the serpentine belt on a 2003 Dodge Dakota?
The serpentine belt on a 2003 Dodge Dakota is replaced by loosening the belt tensioner and slipping the belt off. It can then be removed from the engine accessories and a new belt installed.
Is ther a fix for the serpentine belt slipping off my 1999 Chrysler T and C Van?
You need to make sure that the pulleys are all running in a straight line.
How do you replace the serpentine belt on a Saab 9-5 4cy?
The serpentine belt on a Saab 9-5 4 cylinder is replaced by loosening the idler pulley and slipping the belt off. It can then be removed from the remaining engine accessories and a new belt put in place.
Why would the serpentine belt come off a 1994 dodge spirit when driving through puddles of water?
Several things could cause this such as belt not being tight enough in the first place, or the belt isn't aligned properly, making the water act as lubrication slipping the belt off.
What would cause a serpentine belt to come off?
Many things can cause a serpentine belt to come off. Most likely, it slipped off, or the tensonier that holds it in place was not tight enough.
Why does the serpentine belt keep slipping off the bottom pulley after replacing the belt and tensioner on a 1995 Ford Thunderbird V8 4 6L?
Chances are the belt and tensioner is not the problem. Your water pump is. Check the bottom of the water pump and see if there is some anti-freeze comming from the weep hole. If there is then that is the problem. Anti-freeze will cause a serpentine belt to come off because of its lubricating properties If there are not leaking fluids dripping on the belt that would cause it to come off then, it sounds like a belt alignment problem. You should check your mechanics guide to determine how to adjust the alignment.
Why does the serpentine belt keep walking off the tension pulley on my 2000 firebird?
Pulleys misaligned? Defective tensioner?
What will happen if you attempt to cut hard material with slip joint combination pliers?
Your pliers will keep slipping off the surface. This is not what they are intended for.
