Pontiac Firebird
Ford Expedition Eddie Bauer
Honda Accord DX

Why would the gear shift in a 1995 Firebird not move out of park?

272829

Top Answer
User Avatar
Wiki User
2005-07-26 06:40:21
2005-07-26 06:40:21

Hey Susan==Drinks and coffee can get spilled on the console and gear shift lever. It needs to be taken apart and cleaned and possibly the shifter repaired. GoodluckJoe The shift interlock (device that makes it so you can't pull the shifter out of park unless you have the brake pressed) could also be broken

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 3-4 shift fork in the transmission is bent and will have to be replaced. GM came out with a steel fork that replaces the original aluminum shift fork.

User Avatar

Probably the shift linkage in that model.

User Avatar

I'm assuming your in an automatic transmission. The only thing that i can think of is your in the rough range where you transmission thinks it needs to shift then doesn't or vise versa. Check gear ratios and timing.

User Avatar

If you are referring to the 2nd gear button, that helps by starting the car out in rain or slippery conditions.

User Avatar

If your not starting in low gear check the little snow flake button next to the gear shift. If this has been pressed your starting in 3 rd. gear.

User Avatar

What are the two d's on the gear shift for>

User Avatar

Yep, then shift from second to third gear.

User Avatar

how many gears does a 1995 Yamaha Virago 250 have? And is there anywhere I could look at a picture diagram of what need to take place in order to shift from gear to gear?

User Avatar

truck start shift is hard to move in gear

User Avatar

Stuck in Park? Check to see if the stop lights are working - shift interlock should be the same circuit Check stop light fuse Try turning the key to 1st position (Unlock) Shift to neutral to start vehicle and then shift to Drive

User Avatar

If it is a manual trans, the shift linkage might be loose, bent, or damaged.

User Avatar

Sounds like the tranny. Check the transmission fluid level and the color of the fluid.

User Avatar

My 1997 would not shift out of first gear, was 'throttle position sensor'.

User Avatar

There is no synchronizer gear in these, so you do the synchronization. You're not going to learn about it by reading about it... perhaps a truck driving school would be in order.

User Avatar

No thanks, I do not want to shift to 3rd gear or drive.

User Avatar

700r4 gear shift lever want lock in place

User Avatar

That happens when the transmission computer detects a malfunction and sets a code. It defaults to safe mode which is second gear. You need to have the codes read.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.