turn signal switch needs replaced!
Your problem very well could be the hazard switch. i have a 1994 honda civic too i found whenever i disconnected the hazard switch from the wiring harness my turn signals brake lights and of course hazards do not work. Maybe replace the hazard switch..
The only thing common to all those lights (but not to the center brake light) is the hazard switch. I'd check that next. On my 96 Century the hazards override the signals and brake lights meaning that the signals and brake lights must be wired into the hazard switch somehow.
The multifunction switch inside the steering column is bad.
Check Flasher and/or switch
Check the stoplight switch at the upper end of the brake pedal - common problem
I am having the same trouble. My brake lights work with the light switch for nighttime driving, but only far right brake light works when i pres brake pedal. Reverse lights dont work at all. Turn signals and hazard light work.
possibly the fuse for brake lights......also could be brake light switch----turn signal switch----broken wiring anywhere in the vehicle---relay not working ---any other item specific to your venicle.
How do you replace brake lights
It needs checked out but both the hazard and brake lights go through the turn signal switch.
Check fuse Check stop light switch - usually located at the upper end of the brake pedal under dash area
there was a recall on the hazard light switch that caused the rear brake lights (minus the high mount 3rd light) to stay on. the hazard lights and turn signals still worked. there was only an electrical malfuntion in the hazard lamp switch on the steering column. go to your nearest dealer, they will fix it for free and it only takes about 1/2 hour
Underhood Minifuses control the items in question. Fuses should be labeled, but if not you're on your own. BRAKE (Blue 15a) control brake lampls; HAZARD (Red 10a) controls Hazard Flasher, Inst Pnl, Turn Signals, Park/Turn lts and Rear Tail lts
It looks like the brake lights / turn signals have one of the fuses in common : In the fuse panel located under and to the left of the steering wheel , by the brake pedal , FUSE # 13 - 20 amp - for STOP LAMP SWITCH ( LAMPS ) , TURN / HAZARD FLASHER , and speed control module
It depends on the vehicle but in general you would have one fuse for the signals and one fuse for the brake lights.
if you mean: "why do hazard lights flash when brakes are on", then the answer is because vehicles are equipped with a hazard light relay that supercedes the brake lights. This way, slow moving vehicles can operate under hazard lighting.
Fuse or 4 way flasher unit there are 2 flashers on for turns one for 4 ways
check the brakelight switch. it is located under the dash where the brake pedal rests. Hey its ritchie. If you can click your blinker down and then they work its you blinker switch,but this is my monte.
The problem points to the directional/lights and hazard switch. The brake light wiring is part of that circuit.You can buy the switch after market it is about $70.00.
Where is brake light fuse for 2004 Ford Explorer located
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
Check the bulb it is double filamented with the smaller being for the stop and turn signals
Defective or out of adjustment brake light switch.
Check the brake switch at the pedal.