answersLogoWhite

0


Best Answer

There may be some worn gears/bearings in the transmission, but more likely it's the aligning bushing in the clutch disk.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would your car rattle when the clutch is not engaged?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would your compressor clutch be engaged when car is off?

AC Compressor clutch relay may be stuck. Remove the relay and see if the clutch releases.


What keeps the car in gear?

A car is in gear when the clutch is engaged on the transmission


Why does a car stall when the clutch is engaged?

There are three common problems which are causing your car to stall when the clutch is engaged. These problems are either a worn out clutch plate, a warped pressure plate or disc, or a damaged throw out bearing.


What is the definition of the word engaged?

When two people are in a relationship and are soon to be married, they are engaged. Also, it means that something is in the ready position, such as the clutch of a car is engaged.


How do you Disconnect air conditioner in car?

No ned to. Unless clutch is engaged (AC on) it freewheels-using no power.


What are symptoms that the clutch need to replace?

Difficulty shifting, can't reach first gear and grinds to reverse, have to stomp on the brakes to downshift, basically any sort of unusual difficulty with shifting, car jumps forward when clutch is engaged or moves while on a flat surface and clutch is engaged.


How can you tell What is wrong the car will not drive even with gears engaged and you can change gears while engine runing without pressing the clutch please help?

CLutch is buggered or might just be the clutch cable


Why is the clutch plate on a 1984 Honda Accord still disengaging after it has been replaced?

Hey Renee==I think you mean engaged. Disengaged would mean the car wouldn't move. I think probably the clutch disc is installed backward. GoodluckJoe


How do you say a car 'rattle' in Hebrew?

rattle (car noise) = nekisha (נקישה)


How did you know if the clutch disc has a problem?

If the car judders as it pulls away but the problem goes away after a while the discs are contaminated with water.If the car judders as it pulls away always, its contaminated with oil, suspect a leaking engine seal/gland.if the car overrevs as it pulls away and there is a burning smell, the clutch is burnt out.If the car is in gear but doesnt pull away. The clutch is burnt out.If the car is a manual shift and it creeps if thebrake is off and the car is in gear and the clutch is engaged. Check the clutch adjustment.


How would you fix a really high clutch engagement point What you mean is that the car wont kick in until the clutch is about 95 pulled out?

if there is a clutch adjustment on car, adjust the clutch if no adjustment, you will shortly need to replace the clutch


How do you start a 1991 corvette Do you have to have the clutch to the floor?

Yes...it's a safety feature....so there is no surging in case the car was in gear and the starter was engaged.