0
What else can I help you with?
Your 94 Chevy truck blows the brake fuse when you press on the brake peddle?
There is a short in the wiring or a corroded brake light receptacle.
How do I release the emergency brakes on a Chevy venture 1999?
To release the emergency brakes on a 1999 Chevy Venture, locate the emergency brake lever, which is typically found between the front seats. Pull the lever up slightly to disengage the tension, then press the release button at the end of the lever while pushing it down completely. Ensure the brake warning light on the dashboard turns off, indicating the emergency brake is fully released. Always check the owner's manual for specific instructions if needed.
What causes the fuse to pop everytime you press on the brake pedal?
A short in the Brake light circuit? Bad brake light switch?
Why does signal light stop working when you press brake pedal on 2003 Kia Sedona?
possibly have a brake light out
Is it normal for the brake light an abs light to come on when fressing the parking break?
No , the brake light should come on when you press the parking brake pedal , but the ABS light should not come on
HOW TO RESET SERVICE BRAKE LIGHT 2006 CHEVY C5500 DIESEL?
To reset the service brake light on a 2006 Chevy C5500 Diesel, first, ensure that the vehicle is parked on a level surface and the ignition is off. Turn the ignition key to the "On" position without starting the engine, and press the brake pedal several times. If the light persists, use a diagnostic scanner to check for any stored trouble codes and clear them, which should reset the brake light. Always consult the owner's manual for specific instructions related to your vehicle.
Why does the brake light not light up on 1997 Quest when you turn on the light but it light when you brake?
Brake lights only come on when you press the pedal. The brake light is either a different bulb or filament in a dual-filament bulb than the tail light.
What does a brake light switch do?
just as the name it makes the brake lights come on when u press on the brake pedal
How do you reset the brake pad sensor light on a Chevy Express van?
To reset the brake pad sensor light on a Chevy Express van, first ensure that the brake pads have been replaced or are in good condition. Then, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, which should reset the light. Finally, turn the ignition off and then back on to confirm that the sensor light has been cleared.
I got to press the brake pedal all the way down to get the brake light to come on 1990 Ford Bronco Eddie Bauer?
The brake light switch is out of adjustment.
2001 Firebird hazard light fuse blows when I press on the brake pedal and then the brake lights do not light up?
you need to get a bigger fuse
When the foot brake is pressed what light must go on?
No light goes on in your car when you press the break but when you press the break the street light color you see is RED
