0
Add your answer:
Earn +20 pts
Will a Chevrolet engine fit in a mustang?
it will fit you just have to drill new motor mounts and put a Chevy rear end in the car or a ford 9inch will work
What year engine will work in your 94 ford ranger 4.0?
Any four liter engine should work in your 1994 Ford Ranger cup truck. The Ford four liter engine may need the motor mounts to be changed.
Does a 350 Chevrolet engine fit into a 1986 Chevrolet S-10 Blazer?
yes with some modifing you need motor mounts and headers you can buy the kit but with a little work you can do it. the trans will not fit you need one for a small block Chevy
Can a 5.9 liter engine from one 2000 Dodge Dakota be put into another 2000 Dakota in place of a 4.7 liter engine?
Not without a lot of work. You will need to replace the motor mounts, ECU and transmission. Far from a direct swap.
What type of motor mounts do I use to put a 455 into 66 gto?
Externally they are both the same. The 389 motor mounts should work just fine.
Will a 1997 ford controur motor 2.0 work in a 1995?
No, the motor mounts are different and will not line up.
Can you put a 1993 22r motor in a 1988 frame that had a v6?
yes this will work but you might need to change your motor mounts
Can you put a lt1 motor in a 1989 caprice?
Yes, but the engines mounts are different and wiring. But it will work.
Will a 3.1 liter V6 1994 Cavailer engine work in a 1989 Chevy Beretta?
Yes. The 2.8L MPFI and 3.1L MPFI will use the same motor mounts, sensors, harness, ECM, and fuel injectors. It is virtually a direct swap.
Will a 88 Ford F-150 5-0 liter engine fit in a 95 Ford F-150 truck?
The engine will fit and work the only thing you may have to do is change the motor mounts, the computer and wiering harness but it shoulod be fine
Will a 4X4 transmission out of a 1992 Chevy S10 4.3 liter work on a 350?
Yes it can I am doing the swap right now. If you are doing the swap in a s10 you have to buy headers and motor mounts and a oil filter relocation kit to clear the front diffrental.
How to install motor mounts for 1976 corvette 350 stock?
One way to do it is with an engine hoist. Loosen and remove the through bolts in the motor mounts. Carefully raise the engine with the hoist until you have enough clearance to unbolt and remove the engine mounts. You must be careful and work slowly when raising the eingine, though.
