YES they sure will, It is all a DIRECT bolt up change. It will all interchange with no problems.
a 350 is a small block those heads will fit on and Chevy SMALL block not a big block
No. Not without switching the cylinder heads. I think it was 89, Chevy came out with the 1st generation Vortec heads, which require a different intake.
yes no worries
No it will not unless you modify the intake bolt holes, They don't line up with the late model heads.
The 5.7 heads will work if they have the smaller 184 intake valves . Or you will have to bore the block over to get the 194 ,200,or 202 intake valves to fit into the cylinder if not it will lock it up when the valve opens and hits the edge of the block
Depending on years that you are swapping around....yes. The 305 heads will raise the compression of the 350 considerably. However, the intake valves are a lot smaller than the 350.
It depends on whether or not the intake ports match on the cylinder heads. You can get that info from one of parts exchange guides you may find online.
will 1995 Chevrolet 350 intake fit a 1997 vortec heads
Yes, it will fit.
no the reason no is 88 and later heads they changed the pitch of the inside four bolts that hold the intake manifold on. It wont bolt and and it will not seal if yo do find a way to force it.
Yes it will, if the 350 intake is from a pre-1987 engine.
no