0
Will a bad master cylinder make the check engine light come on in a 1994 Ford Ranger?
Wiki User
∙ 14y ago
No, there is no code for a bad master cylinder nor any brake condition. Your light must be diagnosed using a scanner which will narrow down your problem.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does the Emergency Brake light stay on even when the brake is off in a 1990 Ford Ranger?
Check your brake fluid level in your brake master cylinder in the engine compartment and see if it is down.
What is difference between flashing and steady check engine light in 1999 ford ranger?
A flashing check engine light means an engine cylinder misfire has been detected
Where do you check the fluid on a 1990 Ford Ranger for the clutch?
inside the hood on the driver side fire wall near the master cylinder
Why is the check engine light blinking on a 2004 ford ranger XLT an whit smoke is coming out the exhaust?
If the check engine light is blinking , that indicates a cylinder misfire has been detected White smoke coming out of the exhaust ( especially when the engine is warmed up ) indicates that coolant is getting into an engine cylinder from a bad head gasket , a warped or cracked cylinder head
Why wont the new starter you replaced on your 93 ford ranger 4 cylinder disengage after starting engine?
Check and or replace your starter solenoid.
How do you check transmission fluid on 2003 Monte Carlo?
There is a dip stick between engine and master cylinder has t handle at top.
Why is your brake pedal tight?
check the master cylinder.
What spark plug for 1999 ranger 6-cylinder 3.0 engine?
On a 1999 Ford Ranger : Check the Vehicle Emissions Control Information ( VECI ) decal in the front of the engine compartment , it will show what type of spark plugs to use , and the spark plug gap
What makes a 86 ford ranger 2.9 engine miss fire and run rough on one cylinder still after replacing plugs wires and cap wires are put back correctly?
do a compression check on that cylinder. check fuel injector for pulse.
What if your clutch on your 85 Toyota corolla goes to the floor and is hard to shift?
There are two normal causes. The clutch is worn out or there is a leak in the hydraulic clutch slave or master cylinder. To check the clutch, press the clutch slave cylinder down. If the clutch slave cylinder bellows compresses down to the slave cylinder, the clutch is worn out. Check the clutch master cylinder fluid level. if this is low, then the clutch cylinder need to be checked. To check for a hydraulic leak in the clutch slave cylinder, remove the cylinder's bellows and check for any fluid. If fluid is present, rebuild or replace the cylinder and bleed the system. To check the clutch master cylinder, check the back the of clutch master cylinder for leaks. If fluid is present, replace or rebuild clutch master cylinder and bleed the system. In my experience, hydraulic leaks occur at the clutch slave cylinder.
How do you locate the clutch master cylinder and check the fluid level of the 1995 ford escort?
how do you locate the clutch master cylinder and check the fluid level of the 1995 ford escort
Where do you check the fluid level in the master clutch cylinder of a 1991 Ford Escort GT with a 1.8L engine?
The brakes and clutch share the same reservoir.
