This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
To install a rear bumper on a 1999 Honda Accord place all the mount clips in the appropriate brackets. Clip on the bumper then proceed to screws in the hardware in the correct mounting locations.
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
A 2004 Honda rear bumper cover can be made to fit a 2007 Honda Accord. However, the amount of helper parts to make this fit happen will cost more in the end than it would to have just bought the bumper outright.
behind the bumper
the car with an H in the middle of the hood and/or trunk and says accord above the rear bumper
To professionally repair a bumper on a 2003 Honda Accord it will cost you anywhere from $200.00 to $600.00. However, doing it yourself can definitely save some money.
Possibly, as they are the same generaion. Compare them yourself and you should be able to tell if they are the same.
No, it will not even come close to fitting.
High tone under bumper on driver side...low tone under bumper on passenger side...front bumper.
It is about $300 to $350 in Flushing NY
I just changed mine....I have 2001 Honda Accord (EX-V-6) and the local guy charged me $500. Good Luck!!
Neither, it is plastic.
It is made out of plastic.
1st take off the screws then he old bumper...put the new one in and the return all the screws. EASY!!!
There is a site that shows how to remove the rear bumper in an Accord but it is NOT the 2002 but the 2003 model. I don't know how much different this would be but it might give soe insight. The link is www.cardomain.com/ride/650229/3
Nope, and you should probably use craig's list instead...
There is a screw on the side of the signal, you can reach it through the middle of the bumper. unscrew that and the whole signal will come out of the bumper. pop the clips and then the lens will come off
remove the square pop-out on the bumper and there is a screw on the outside of the light
Bumper, & manual transmission are different. All other parts are interchangable.
remove plastic rivets and bolts holding bumper within fender well, between lights near hood latch, and bottom of bumber, be careful taking bumper off to prevent cracking. exact opposite for installing bumper
yes it does fit...94-97 have the same bumpers. Someone else answered the above statement. I answered below, and have actually done this. 94-95 have the same bumper, pretty much exactly. 96-97 has a different bumper, but it can fit on the 94-95. A 96-97 bumper can also fit a 94-95 bumper. The bumper brackets are different though between the two models. Whatever year the bumper is for, get that same year bracket.