Want this question answered?
Manual Transmittion - Flywheel to Crank - 105 Foot Pounds Pressure Plate to Flywheel - 33 Foot Pounds Automatic Transmittion - Flex Plate to Crank - 65 Foot Pounds
depends on the engine size the 4.6 flywheel to crank is 62lbs and pressure plate to flywheel is 18lbs
It can Only go on one way. The side where the springs stick out further go toward the pressure plate because they will hit the flywheel befor you can bolt on the pressure plate
It's a standard thread not reverse threaded. Same with the automatics flex plate bolt and manual transmission's pressure plate bolts.
Can i have the clutch pressure plate bolt torque setting not the FLYWHEEL BOLT
you first have to drop the transmition. there is one bolt on the transmission support and 4 on the engine . after that you will have to separate the pressure plate from the flywheel and then change the clutch
Remove either the engine or transmission, remove the pressure plate from the existing flywheel and examine both the pressure plate and clutch plate, unbolt the flywheel from the crankshaft and remove it. If there are many miles on the clutch, don't even TRY to reuse it. Examine/replace the glan nut/pilot bushing as necessary and lubricate according to specifications. Bolt the NEW flywheel onto the crankshaft. Using a pilot shaft, install the clutch plate/pressure plate assembly. Make sure the shaft can be removed easily and that the clutch plate is centered exactly on the pilot shaft. Install the engine or transmission. If you haven't done one before, good luck.
It is easier to do if you install the torque convertor to the transmission and then attempt to bolt it to the flywheel. You will have to turn the convertor or flywheel to line up the bolt holes.
will 4.6 windsor engine with 6 bolt flywheel interchange with 8 bolt flywheel
Pressure Plate = 25 n.m. (18 ft lbs)Flywheel = 80 n.m. (59 ft. Lbs)~MFG Racing
You have to have a special tool. It mounts to the side of the flywheel, then you screw the bolt into the plate onto the center shaft and it pushes it off...
The Chevrolet small block 400 will bolt in place of the 305 but be sure to use a 400 flywheel or flex plate. Do not use the 305 flywheel or flex plate on the 400.