Actually, not at all, they are different size, plus the engine will not produce enough torque to the transmission
can be, starter bolt holes,bellhousing holes.
measure both bell housings,dont think they are the same
it is inside the bell housing
The slave cylinder for a hydraulic clutch is inside the manual transmission bell housing
I am converting a ford ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder ford ranger. Will it work. What is needed?
The v-8 and v-6 transmission bell housings are a different size and you can't change the bell housings. So no. won't work.
The Ford 302 engine will not bolt to the 300 six-cylinder bell housing. A new bell housing or a Bell housing modification kit will need to be used.
The slave cylinder for your hydraulic clutch is located inside the transmission bell housing
It is located inside the bell housing.
I believe that is inside the manual transmission bell housing
it is attached to the bell housing and makes contact with the clutch fork.
The bleed valve is located on the drivers side of the bell housing.