Yes they will fit, but it will also raise the compression on you 350 by .5-.8. Also the gasket thickness and pstion, etc. will determine compression, also the valves are smaller, 1.885/1.5 i believe.
will 1995 Chevrolet 350 intake fit a 1997 vortec heads
To make a crankshaft position sensor work on a 1997 Honda passport with a 1995 block and 1997 heads will take a lot of work. You will have to redo everything under the hood.
yes they will fit, but you will need an intake manifold compatible with vortec heads if you plan on reusing the carburetor
no sorry they are cast iron.
yes, you can use those heads. the block does have small changes to it but no problm will occur
vortec 454,1996 thru 1999-->>>290HP 410TQ
No it will not. Those 2 engines have a total different type of fuel system and sensors.
All 1997 GM vehicles were fuel injected and all had the electric fuel pump mounted in the fuel tank. None had a mechanical fuel pump mounted on the engine block. A 97 Chevy 350 Vortec uses an electric fuel pump and sender assembly in the fuel tank. If it is a true 1997 block, then it doesn't have a place for a fuel pump on the block.
YES it is.
1.8.4.3.6.5.7.2
DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL DONT EVEN TRY IT THE HEADS ARE DIFFERANT BUT THE BLOCK IS BASSICALLY THE SAME BUT ITS NOT WORT THE HASSEL
there are usually several in the engine block just below the cylinder heads. most are round or oval, and are recessed into the block.