0
Will taking out the two cadillac converters and putting a straight pipe on my mercedes e430 damage my car?
Slavikkb
Add your answer:
Earn +20 pts
When was Putting It Straight created?
Putting It Straight was created in 1977.
When did they start putting catalytic converters on cars?
The first year for Catalytic converters was 1975They were first required on all cars in 1975.
Where can one look to find a world currency converter?
World currency converters can be found on the websites of most foreign exchange sites and newspapers sites. It is even possible to get a conversion by putting the search term straight into Google and that will return a response.
How to reset cadillac deville air ride suspension?
A person can reset the air ride suspension on a Cadillac Deville by disconnecting the compressor wiring harness from the compressor itself. This is accomplished by putting the vehicle on ramps.
At what mileage do you change Mercedes c180 timing belt?
Mercedes is real good about putting that info in the owner's manual. I have a 2007 CLS 550 coupe and all that info is available in the manual(s).
Can i get a schematic for putting a serpentine belt on a 1994 Cadillac sls Seville northstar v8?
The diagraim is under the hood. Look harder
Brand new battery won't stay charged in my 1998 cadillac?
The battery is bad or the alternator is not putting out the correct voltage and is bad.
What type of tool do you use to insert a spark plug in a Mercedes-Benz ML 320?
carefully putting the WA 2000 into the engine
Why won't the glow plug light come on after putting new glow plugs in a 1982 Mercedes 300D?
Try checking all connections and the solenoid.
Cadillac 97 sts idles high but not all the time?
I found that putting low grade gas in car mad it idle high. Does it every time
What type of oil should be used in a 2002 Cadillac deville?
I can't remember when Cadillac switched to 5w30 from 10w30 on the Northstar engine. Pop the hood and take a look at the oil cap, it will say right on it. GM was pretty good about putting oil weights on the cap.
Why should you tilt a graduated cylinder when you drop objects in them?
Tilting a graduated cylinder when putting something it in is is so that the object will not break. If you just drop the object straight in it will go straight to the bottom and break.
