NO! haha.. check out www.preludepower.com .. under the 3rd gen section there is a search function. Search for H22 swap.. it is a very popular swap.. but tedious and expensive. You need new mounts, they are not the same. You need new CV axels, wiring harness modifications, unless you can modify a radius rod, you will lose A/C. I'm sure I have left things out.. best of luck to you!
Yes you can I have 1988 Honda prelude with the 2.0L in it.
my 1988 4ws Honda prelude idles low at 600 rpm
Yes, the 1988 and 1989 Honda Prelude has a VSS that is a cable sending unit that connects to the gauge cluster in the dash.
where is the fuel pump cutoff relay located in a honda 88 prelude?
None of the dashboard lights work on my 1988 Prelude. Why?
I just went through that exact problem with my 88 prelude, it was the ignition cylinder.
Screwed into the head.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
under left hand head light
Yes. All Preludes do.
The 88 Prelude does not use a dual timing belt. It has a single timing belt
The throttle body diagram for the 1988 Honda Prelude is found in the maintenance manual of this car. It can be obtained as a print out from an automotive store as well.
The fuse for the heater and the CD player in Honda Prelude 1988 can be found using?æa fuse diagram. The diagram is available online and can be found by looking for '1998 prelude fuse panel diagram' on any search engine.
Hey they usually come with a 2.0 litre b20a motor
Yes it will fit, all of the twin cam third gen preludes 1988-1991 have the same motor config. You can even put the fourth gen vtec prelude motors in the third gen chassis with mount kits.
the oil filter is located on the back side of the block in the middle
Yes, with some custom mounts for the engine and transmission. This can be expensive if you have a shop do the work for you.
Most of them just drive out. Get the new ones and you will see how they install.
If its a 4 wheelsteer model look towards centre of the car.
20 inches on the driver's side, 19 inches on the passenger side.
if its a 2.0 then 2.0 liters of oil! 2.0 is the engine size, a 1988 Honda prelude 2.0 holds exactly 4 quarts of oil, i just changed my oil today and it says that in the owners manual.
12 gallons. 88, 89, 90, and 91 all have a 12 gallon fuel tank.
The answer is no. The fuel-injected engine from your 1987 Accord is a direct-fit into a 1985-1987 Prelude Si, but will not fit into a 1988 or newer Prelude due to a completely different engine and transmission being used. The wiring harnesses and ECU will also be very different.
If it is a manual transmission you do not have transmission cooler lines. If its an automatic they will be on one side of the radiator and you can follow them to the tranny from there.
on the passenger side under the hood, it is black and round with either a hose at the top and bottom or two hoses at the top.