A front popping on the left of a 98 Blazer could be the brakes, steering, or wheel bearing. Check all three to find the cause.
you might want to check the brakes and roters they might be broken or warped...that would be the my first guess...then you might check the alignment
Likely a loose or broken strut or shock. Could be the same for a load leveling bar, depending on the vehicle.
Possibly a broken motor mount. If it runs good otherwise one cause can be a vacuum leak. The check engine light should be on if it is a vacuum leak.
the clutch release could have broken , the brakes could have locked, the engine could have blown, the transmission could have broken. These are mostly things that have happened to our ranger. It depends what you mean by stops
The most common cause is failure of the Master Cylinder. Leaking wheel cylinders & calibers is another cause. Of course worn brake pads or shoes can cause defective brakes. Lastly would be a broken brake line hose.
prob a broken belt in one of the front tires
That happened to me not long ago. It was cause by rib damage from a car crash
The most common cause is a broken or corroded ground wire.
check for loose caliper bolts, brake pad may be moving around in caliper or caliper bracket. missing or broken brake hardware.
What would cause a grinding noise after a tire is replaced and the brakes are not worn?
The year, make, model and engine would help us.
Possible causes of popping/grinding noises when turning:Wheel bearingsCV joint / axleBrakesSee "Related Questions" below for more
It would be against the law for a motor manufacturer to fit a light which could cause the brakes to fail.
hard breaking or no back brakes. also, back brakes adjusted wrong.
could be the CV jopints of the car
Typically, a knocking noise when to use your brakes in the car is caused by your brakes wearing down. This means you need to get them checked out and repaired.
Check you brake fluid and lines. It may be as simple as bleeding your brakes.
The cause can be traced to a few things. Number one the master cylinder may have failed. Number two you could be low of brake fluid or have none at all due to a leak or broken brake hose. If the power brake booster fails you may think you do not have brakes because it requires an excessive amount of pressure on the pedal to activate the brakes. Whatever the cause do not drive this car into you have the brakes repaired.
Have the brakes checked.
A leaking manifold seal on the intake will cause a popping noise on the 1996 Honda Accord. This can heard most clearly on days when the weather is cold because the seals tend to shrink.
probably means you are running out of gas
My 2007 Murano has squeaky brakes when I first start out, usually in the morning or after sitting for awhile. After a minute or so, the squeak goes away. The brakes work fine.