Scroll down to related links and look at "Interconnection of two units" and find the picture of the amplifier and the loudspeaker. Learn about "voltage bridging" - Zout < Zin.
At the rear of the receiver there is a single RCA jack (phono socket) that is marked "audio out" and "sub-woofer". This is a mono feed that can be connected to a powered sub bass unit. It will not drive an un-powered bass speaker that does not have an internal amplifier. If the bass speaker is not powered, the audio out from the receiver can be taken to a single channel of another amplifier and the bass speaker then connected to the speaker output of the amplifier.
Possibly, if you turn the volume up, but not necessarily. You should attempt to match impedance (your amplifier is designed to have specific speaker impedances connected, if these are not connected it will not deliver full power).
No. Load resistance is the value of the element actually doing the work of the circuit it is connected to. A speaker connected to an amplifier is the load.
A microphone connected to an amplifier and speaker(s).
What I have done before is i attached wires from my door speaker and connected my sub. It sounded pretty good.
The first computer speaker was an ordinary speaker with vacuum tube amplifier connected to the MSB of the accumulator, it was used to assist in debugging. It looked no different than an ordinary audio speaker of the time.
Depends on the output of the amplifier.
A microphone is usually connected to an amplifier.
Electrical - mechanical - sound. From electrical energy, electricity is passed unto an amplifier, a microphone or a cdplayer is connected to the amplifier. The amplifier then change the sound entering it into mechanical energy. Then sound is passed out through a speaker cable givin sound energy
In the radio, there is no other amplifier.
Speaker cable is used to connect the speaker outputs on audio devices such as a receiver or amplifier to the inputs on the speaker(s).
Scroll down to related links and look at "Interconnection of two units" and find the picture of the amplifier and the loudspeaker. Learn about "voltage bridging" - Zout < Zin. There are no power amplifiers with a high impedance output.