answersLogoWhite

0


Best Answer

Could be a bad fuel pump.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your 1990 Chevy 1500 v6 won't start have replaced the plugs wires cap and rotor along with the ignition coil has good power will crank til the battery dies but won't start done a spark test HELP?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Where is the fuse that is between the alternator and the battery on a 1996 Chevy Astro 4.3L?

The fuse between the battery and alternator is a fusible link in the small wire that hooks up to the battery terminal along with the regular battery cable. It looks like a thick spot in the wiring. To replace, the cable must be replaced. .


When changing the ac compressor on a 1997 Chevy blazer what else needs to be replaced along with it?

The collectr and all applicable o rings


Where is the ignition module on xg falcon?

ignition module is inside distributor along with hall sensor


How do you determine if your ignition switch needs replaced on your vehicle your fuel pump relay AC relay and check engine light won't come on The car won't start no power in relay wires.?

Along with the ignition switch, there's a neutral safety switch that could be bad, VATS key chip relay if you have this, and possibly fusible links near the battery. Other than that, it COULD be the starter relay. The wire from the ignition should be either purple or red at the solenoid. If there is a small black wire at the solenoid, it should come right from the battery. The VATS can definitely open this, better if you don't have the chip key when this happens. Find the procedure to wire around it, at least temporarily until you verify it is not the problem. Good luck.


Can keys be replaced if you lost the keys to your car to start the car on a 1999 Buick Regal?

You will need to take proof of ownership or registration to a buick dealer, along with the vin number, but they should be able to get it off the registration. Now If the car has ever had the ignition replaced it might not work. I acutally lost the keys to my Avalon in a drunkin stuper, which was a good thing, and had to got to the dealership and do this

Related questions

Mazda mx3 1994 4 cylinder your battery light is coming on along with engine electrical light sometimes you replaced the battery and the battery light still comes on sometimes along with the engine ele?

Alternator


Why when you turn the ignition key nothing happens?

It could be a bad battery, or connection. A bad starter and or solenoid could be the problem, along with an ignition switch to name a few.


You have got a Chevy cavalier z24 1997 it misfires on cylinders 2 and 3 you have replaced the coilpack and ignition module along with plugs still misfires any answers to this?

How about the plug wires? If plug wires don't fix it I'd bet it's the injectors.


What is wrong with a 1992 Acura Integra when it won't crank?

There are a lot of things that could be wrong. If you hear a clicking noise, it could be: -the alternator isn't charging the battery so it won't have the power to at least turn over -the battery is dead from other reasons than the alternator -wiring is grounded out somewhere along the ignition wiring -bad ignition switch -bad relay -bad fuse -ignition coil is defective -distributor cap is defective -rotor needs to be replaced ....sorry there are a million reasons....try check the battery and alternator and go from there...


Where is the fuse that is between the alternator and the battery on a 1996 Chevy Astro 4.3L?

The fuse between the battery and alternator is a fusible link in the small wire that hooks up to the battery terminal along with the regular battery cable. It looks like a thick spot in the wiring. To replace, the cable must be replaced. .


1974 pickup 390 mtr has been converted to electronic ignition The ignition fried Replaced ignition and coil Ignition switch is good but still no spark Can anyone help?

You'd have to describe the components you replaced. Did you use a plug and go all in one distributor or did you replace the coil, distributor, and add an electronic ignition unit? If you "fried" your ignition, it's likely you fried something else along the line too. Check all your components.


Your trailblazer wont start and it seems as if the power is being drained but its not the battery what is it?

I have the same problem with my 2003 along with many others. There is a whole thread on this issue some say changing the battery is the cheapest first step and or check the battery connection for corrosion. Some say replace the ignition switch as GM replaced the switch on 2004+ models. Could also be the starter solenoid. I wish there was an answer here already.


The ignition in your 1990 bronco wont engage the starter and causea the battery power to remain on already changed the lock cylinder without result?

the ignition actuator is broken, you can turn off the "battery power" by the the ignition actuator rod that leads to the ignition switch, it runs along the top of the steering column under the dash, locate it and pull it towards the steering wheel, this should shut off the power. or you can unhook you battery, but either way you will have to replace the actuator.


When changing the ac compressor on a 1997 Chevy blazer what else needs to be replaced along with it?

The collectr and all applicable o rings


How can you tell if Chevy Lumina has abs?

THere should be an ABS warning light that comes on briefly along with all the other indicator lights when you turn the ignition on.


What car replaced the Chevy Lumina?

The Chevy Impala (which closed out in 1996 along with sister Caprice) replaced the Lumina in 2001. Although it was assopsed to replace it in 2000 Chevy decided to keep it 1 more year. That final year sales plunged down to half of the previous. THEY STILL MAKE LUMINAS! But not in north america.


You have replaced the distributor cap and wires on your 1983 Chevy s10 blazer and you still do not have a spark?

i just had the similar problem. i repaced the coil pack an the ignition module. they are not hard to do. if then you still have no luck replace the distributor itself. its not hard to do but you will need to check the timing once you have it running. get yourself a chilton an haynes book. it will help you along the way. best of luck.