0
Check the starter solenoid and the starter itself. Either one could be stuck and causing the constant engagement. Check the flywheel for damage after you fix the problem.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is wrong with your 1994 Saturn SL1 if the starter keeps going out?
If it is because of the drive, it may need a flywheel also. If it keeps burning out the wiring, I would change brand of starters.
Can a bad neutral safety switch on a 1999 Jeep Cherokee prevent it from starting?
The neutral safety switch keeps the starter from engaging when the transmission is in any gear EXCEPT park or neutral. A faulty switch would either allow the starter to engage any time or not allow the starter to engage at any time.
Why does your starter keeps going after car is running on a 1997 Chevy cavalier?
Could be a bad starter solenoid (return spring not strong enough to disengage) Could be a bad ignition switch (does it release if you shift to "Drive"?)
Why Chevy 350 starter keeps cranking occasionally you have just installed a new motor all wiring is correct?
If The Starter Is Hanging In The Ring Gear When You Are Starting The Engine. It Would Most Likely Be A Bad Starter Drive. Sorry For Not Including ThisAnswerIf I Understand Your Question, You Are Asking Why The Starter Motor Keeps Running After You Let Off The Key. You Have A Bad Starter Solenoid. Also Your Ignition Switch Could Be Acting Up. Check The Starter Solenoid First. Good Luck Sounds to me like you need to shim the starter. It should have come with shims when you bought it.
How do you adjust a belt on a 91' silverado?
There is no adjustment. It has a tensoner that keeps the belt tight.
Starter keeps running even with key removed?
If the starter keeps running when the key is removed, you have two wires touching that should not be. It can also be a bad solenoid. Either one can start a fire.
Why does the starter fuse keeps blowing in a 2000 Saturn sl1?
Check the wiring on the starter. Also check all grounds
Fuse for your ignition fuel starter keeps blowing when you try to start your 1996 Chrysler cirrus lx?
the starter has failed.
Why does your s-10 starter keep turning after the motor has started and you have to pull the starter relay to stop the starter?
This usually means a sticking solenoid that keeps the starter engaged after activation. The fix is to remove the starter and clean but my s-10 starter is a closed unit so you will have to replace the complete starter and solenoid unit.
How do you remove a starter on a ironhorse Texas chopper?
I have a 2003 iron horse and had starter rebuilt , I'm wondering is there suppose to be a shim , it keeps blowing out my clutch
Which part of the computer keeps files?
The disk drive.
What is the starter lockout switch for?
AnswerOne of two things. It can either be a nickname for the "neutral safety switch," which keeps you from cranking the car unless it's out of gear and (usually) the clutch is depressed, or it's a switch that keeps you from cranking the car when it's already running. Answerbad bendix or bendix wiring?AnswerDo you mean when you turn the car off, and it keeps running, if that is the case the wiring on your alternator is reversed, if it is the starter that keeps running it could be the bendix wiring is crossed or getting a current from another wire. AnswerWhat is bendix wiring??? I am a licensed mechanic and Ive never heard of that one?? Your ign switch could be sticking sending power to your solenoid ,or the contacts in your solenoid or your plunger could be stuck / sticking. Which is not unheard of .Or you may need to shim the starter due to the fact the clearances are too tight causing the starter drive to stick in the flywheel. Holding the solenoid contacts closed.
