0
Your key is stuck in ignition how do you remove from 1988 corvette?
Wiki User
∙ 15y ago
Does it have an automatic transmission? If yes look on the lower part of the colunm as you move the shifter you will notice it moving , When you move the shifter from drive towards park note the direction it moves then reach done there and with your hand continue to rotate the collar as you place the shifter in park this will release the locking mechanism so the key will come out.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you remove the ignition module on a 1988 ford f-250?
how do you remove the ignition control module on a 1988 ford f-250 pickup?
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
Replace thermostat on 1988 Corvette?
Drain the water from your 1988 Chevy Corvette cooling system. Remove the water supply hose from the top of your thermostat housing. Remove the thermostat housing bolts. Remove the thermostat. Reverse the process to install the new thermostat.
How do you Replace starter in 1988 Corvette?
You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
How fast does a 1988 Corvette go?
A CORVETTE 1988 goes up to about 180
How do you remove an ignition lock cylinder from a 1988 Mazda 323?
With an uncle and a hammer.
How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you remove the ignition switch key lock on a 1988 Jeep Cherokee?
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
Is there airbags in a 1988 Corvette?
NO.
Can 1988 Corvette door panels fit a 1986 Corvette?
yes.
How do you remove the ignition switch from a 1988 Dodge Ram 50?
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
Where is ECM electronic control module on 1988 Corvette?
The ecm on a 1988 Corvette is mounted under the dash on the passenger side, I just had to get one for mine and it took the junk yard employees 2 hours to find and remove it. You will need to talk to a Corvette mechanic or look through a manual with exploded views to find out how to get it out withour distroying the trim. The ecm on a 1988 Corvette is mounted under the dash on the passenger side, I just had to get one for mine and it took the junk yard employees 2 hours to find and remove it. You will need to talk to a Corvette mechanic or look through a manual with exploded views to find out how to get it out withour distroying the trim.
