answersLogoWhite

0


Best Answer

There should be an access panel on the inside of the door which covers and inside door release mechanism. ed724 You need to remove the bottom panel (the panel below the rear window). To do this, get into the van (it helps to remove the rear seats), pop the plastic cover over the pull-down strap (this cover actually slides up), and the covers on both sides of the handle (these covers will pop from the front; use a flat-head screwdriver, insert it from the top). Once you get the covers off, remove the bolts using a 10mm socket. Remove the panel. I found out that it's easiest to remove the panel by pulling out from the bottom. Don't worry about pulling it. It's held only by pull-out pins. Once the cover is off, locate the latch. Just pull up on it and it should unlatch. Be careful not to fall off the rear of the van. Nando

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Your rear hatch door latch is broken How do you get into it to fix it you assume it is the cable The door is shut and you can not open it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where do you locate the hood latch under the hood when the cable is broken?

dodge truck broken hood latch


How do you open a bonnet on a Fiat Palio Go 2006 when the latch is broken?

The latch is broken, not the cable. You can still get to the cable where it is attached to the latch in the foot-well of the car. Grab the cable with a small vice-grip (or similar) and pull. Note that it is very unlikely the cable will break -the latch typically breaks before the cable since the latch is made from plastic and the cable from steel wire.


How can I open the hood with a broken latch releasedetached cable on a 1999 ford windstar?

you can get to the latch through the grill


How do you open the hood on a 94 geo with a broken hood latch cable?

If it is just the inside handle broken off you can pull the cable with a pair of pliers. If it is in the middle, you should be able to reach up from underneath and cut the cable and then pull the inside cable. If the latch end has pulled off, you may be able to trip the latch from underneath, or take the grill out and unbolt the latch.


How do you open the hood on a 1992 Buick Century when the hood latch is broken?

Use a set of pliers to pull the cable even if the plastic latch is broken...


You have broken Hood latch cable on a 1989 GMC Vandura How do you open the hood Thank you?

where your latch is broken at you can use a pair of pliers and pull the exposed cable wire and it should open best thing when u open it replace the cable wire


Car door wont open from inside?

The cable between the latch and the handle may be broken or needs adjustement to shorten the cable so that the latch will fully release.


How do you open your rear hatch on your Toyota Sequoia if the latch is broken?

Our mechanic had to climb through the inside of the car, into the trunk area and open it by removing the hatch cover. That's the only way he could replace the latch.


How do you release a broken latch with a broken cable on a 1988 Ford Explorer?

use the gas tank to masturbate and ejaculate in the engine


How do you open a 1985 subaru gl wagon hood with a broken hood latch cable?

Take the grill out and remove the bolts holding the latch on.


How do you open a hood latch on a 1996 dodge van if the cable is broken?

You can try unscrewing the grille and getting your hand or tools up to the latch.


How do you open the hood on a 94 Plymouth grand voyger with broken latch?

Need more information. Is the latch behind the grill broken? Or is it the latch operated from inside the vehicle? If it's the latter you can remove the latch mechanism and pull on the cable using pliers or vise grips.