If you are running a remote start solenoid, which is completely away from the engine heat, and still having problems I doubt that the Corvette solenoid will make much difference. One other thing to check is your initial timing. If your timing is advanced a little too far it can cause these same symptoms. Before changing out that solenoid again or spending more cash dial back your timing a few degrees. See if the hot start problem is still there. It's free and would only take a couple of minutes to check. If the problem is still there you might want to check or replace the starter itself.
Why is 94 corvette running hot
== == Try tapping on the solenoid(smaller cylinder attached to starter) while someone tries to start it. If it starts then the solenoid is bad and the entire starter solenoid needs to be replaced.
Bad starter, bad starter solenoid, or the problem might not be the starter at all.
We are having the same problem on a 2000 Corvette, were you able to figure it out?
Sometimes the cylinoid will make a loud whine or humming when engaged if bad but the best way to tell is to remove it and have it tested.
it could be the crank sensor as it is a problem for the altimas.
You need to replace the starter solenoid .
I just had this problem and had to replace the torque converter. Also the two three solenoid was bad..
The problem is almost definitely your neutral safety switch. When you jump the solenoid you are bypassing it. The problem is your starter is going and needs replacement
1. You have just installed windows 98. During testing, if fails to start after the "starting windows 98" message appears. What should you do to troubleshoot this problem? Name at least two ways.
a lot of different stuff
Remove the starter and take it to your local auto parts store for testing.