0
What else can I help you with?
What is the correct tightening procedure for the wheel bearing?
desribe the correct tighting procedure for the wheel bearing
What is the cost for a wheel bearing replacement?
The cost for a wheel bearing replacement will vary based on the brand of the car. For example, a Lexus dealership quotes cost averaging about $800 for a replacement.
How do you pack wheel bearing on a car?
probably a replacement item. A wheel bearing assembly. Just a bolt on piece.
What is wheel bearing replacement cost nowadays?
A wheel bearing replacement price rangers from around $250 to $400 depending on what model and type you are searching for. I hope this answer helps you.
1992 Acura Integra front wheel bearing replacement?
Remove the tire and wheel. Remove the and to the axle. Remove the wheel bearing seal, with a seal puller. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Is the rear wheel bearing replacement procedure the same on a 2000 Chevy S10 and a 1998 Chevy S10?
Yes it is . The only difference may be drum or disc brakes.
Rear wheel bearing replacement for 1982 corvette?
Remove the tire and wheel from your 1982 Chevy Corvette. Remove the brake assembly. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.
Wheel bearing replacement on a 1994 olds 88?
Front or rear?
Can clutch replacement cause wheel bearing fault?
not if you re pack the bearings!
What is an estimated cost to replace wheel bearing on 95 Ford Ranger?
I had a bad right front wheel bearing on my 2004 ford ranger 4X4. When the mechanic took it for a ride he swore it was the left front wheel bearing that was bad but when he got it on the lift it turned out to be the right front.300 dollars for the part and 85 dollars for the labor plus tax.
Where can you get a wheel bearing replacement diagram for a 2000 KIA Sportage?
2wheel id different than the 4 wheel ,which do you need ?
Why would 01 Stratus have transmission leak after wheel bearing replacement?
When the wheel bearing was replaced did the axel get pulled out of the transmission ? it might not be all the way in ,or it could of hit the seal and tore it !
