0
What else can I help you with?
How would you fix a stuck accelerator pedal on a 1999 Ford Explorer?
Chances are the throttle cable from the pedal to the throttle body needs replacing.
Where is the throttle lever and throttle cable found on a 1994 ford explorer?
On my 1994 Mazda Navajo, which should be the same as an Explorer, their is a black plastic cover with 3 bolts on top of the engine. When you remove the cover the throttle and cruise control cables attach to the throttle lever there. My throttle is sticking but the problem seems to be where the cable attaches to the pedal.
What to do about gas pedal sticking on a 1996 ford explorer?
Check the throttle plate, gunk builds up that can be cleaned with carburetor cleaner. Next try lubricating the cable ... if that doesn't work then replace it.
Is there any site that shows pictures r videos of where the throttle sensor may be on 1996 ford explorer?
The throttle position sensor is mounted on the side of the throttle body
Where is the map sensor on 1996 ford explorer 5.0?
The MAP sensor on a 1996 Ford Explorer 5.0 is located on top of the engine near the throttle body. It is bolted to the engine and also has a wiring harness attached to it.
What causes gas pedal to stick while driving a 1996 Ford Ranger?
Take it to a mechanic ASAP. This is very dangerous. a cause of is the throttle cable fraying replace the throttle cable.
How do you replace a broken throttle cable on a 1988 Ford Ranger?
how do i replace a throttle cable on a 1988 ford ranger pickup
Is there a speedometer cable on a 1997 Ford Explorer?
I believe starting on the 1996 Explorer , it went to an electronic speedometer with a vehicle speed sensor ( VSS ) so it doesn't have a conventional speedometer cable
Where is the air intake sensor on a 1996 ford explorer?
In the big rubber air intake tube , not too far from the throttle body
What type of freon to use on 1996 Ford Explorer?
On a 1996 Ford Explorer : ( r134a )
How do you replace throttle cable on 1989 ford bronco?
To replace the throttle cable on a 1989 Ford Bronco, first disconnect the negative battery cable for safety. Remove the old throttle cable by detaching it from the throttle body and the accelerator pedal assembly. Install the new throttle cable by connecting it to the throttle body and fastening it to the accelerator pedal. Finally, adjust the cable for proper tension and reattach the battery cable before testing the throttle operation.
How to Open hood with a broken cable on 1994 Ford Explorer?
how to open hood with a broken cable on a 1994 ford explorer
