The fuel level gauge is in the tank
you would have to hook the vehicle up to a scan too and u can look in the bcm and it will tell u the fuel level if it doesn't match the fuel gauge ur cluster is most likely bad
The fuse box for the fuel gauge on 1998 Chevy blazer is located on the driver side. It is near the hook latch.
Hook a fuel pressure gauge up to the shrader valve on the fuel rail.
Hook a fuel pressure gauge up to the shrader valve on the fuel rail.
The fuel gauge fuse on 1998 Chevy blazer is located in the front of the blazer. It is on the driver side next to the hook latch.
there are 2 wires on the replacement fuel sender for my Kubota RTV. where do I hook the 2 wires?
To hook up a gauge to measure fuel preasure and to run injector cleaner through it Fuel line pressure release valve. (schrader)
the purple wire
you hook it up to the white wire that comes out of your O2 sensor
Get a fuel pressure test gauge making sure you get one that can handle your pressure. Hook it all up. Run engine. Then as soon as you turn off engine, crimp off fuel return line to gastank. If pressure drops you've got a stuck open injector or other leaks.
Did you check the fuel pressure? You may be running out of fuel. There is enough pressure in the fuel line when you have the key on, and the pump is pumping but as you use up the fuel in the line the fuel pump can't keep up and you lose pressure and the fuel shuts off. Get a fuel pressure gauge and hook it inline on the fuel rail and see what pressure you have with just the key on, and then start and run the engine and watch the gauge. If the gauge drops, your fuel pump is likely on it's way out.
Crossfireinjection.net sells some nice hard piped kits that hook between throttle bodies. Otherwise you have to install a t with a shrader valve on the rubber fuel line, preferrably after the filter. Then hook a gauge 0-15 psi preferrably to the bull end of that T.