0
What else can I help you with?
How do you time a 389 tri power?
With a timing light and by loosening the distributor is how use set the timing, I think around 34-36* degrees at 3000rpms, need to double check thou.
Your 1992 cutlass supreme loses power and then regains it The voltage gage show it has 34 of the whole power gage?
There may be a problem with the alternator not putting out enough voltage. There could also be a problem with the oxygen censor malfunctioning as well.
If 12 counters are 34 of a set what is the whole set?
16 is the whole set
What is the mode of 31 34 34 35 and 36?
The mode of the set of numbers {31, 34, 34, 35, 36} is 34, as it is the number that occurs the most.
1986 Chevy 350 320 horsepower 9.2 compression mild cam flat top pistons edelbrock dual plane and quadrajet automatic trans what should the timing be set at?
32-34 degrees
What are the common multuples of 34?
Multiples of 34 include 34, 68 and 102. For them to be common, they need to be compared to another set of multiples.
What Chief Justice of the US Supreme Court served more than 30 years?
john marshall was the supreme court chief justice for 34 not 35.
If 75 counters are 34 of a set how many counters are in the whole set?
To find the total number of counters in the whole set, you can set up a proportion. If 75 counters represent 34 of the set, you can write it as ( \frac{75}{34} = \frac{x}{100} ), where ( x ) is the total number of counters in the whole set. Solving for ( x ) gives ( x = \frac{75 \times 100}{34} ), which calculates to approximately 220.59. Since you can't have a fraction of a counter, you would round to 221 counters in the whole set.
What is the most valuable leadership quality for a supreme court chief justice such as John Marshall?
34 years
I set the timing on my 1988 Chevy with the timing connector off at 0 degrees but when i plug the connector back on it is way off Help me pleas?
According to your shop manuals (Chilton's, Haynes, etc.) it states to set the timing to 0 degrees with the advance unplugged. You then need to disconnect the battery to let the ECM reset, plug your advance back in and re-connect the battery. Now when you check you timing again it will be well advanced from the 0 degrees you set it at, this is normal. However, I have recently spoken to two separate professional enginge builders and they have told me that setting your timing to 0 degrees is wrong, they both have stated to set it to 10 degrees BTDC with the advance disconnected. They have also told me that you should not have more than a 34 degree advance at 2000 rpm at any time. 0 degrees timing causes your engine to run a little hotter, which I have experienced and you have a potential to crak a head, also something I have personally experienced.
What set of numbers has the mean of 34?
There are an infinite set of numbers whose average is 34. {33, 35} {33, 34, 35} {33, 33, 35, 35} {1, 1, 1, 133} These are just a few examples.
Is the number one cylinder closest to the distributor or the timing belt?
Distributor- 4-3-2-1- timing belt 34 12 (looking at distributor firing order)
