Replacing a engine in a Ford Capri can get pricey. An engine can cost anywhere from 400 dollars to 5000 dollars depending onn what shape it is in.
A 1993 Mercury Capri (with the 1.6 4 cylinder DOHC engine) requires 3.2 quarts of oil.
For the 1991 Mercury Capri, the cylinder numbering follows the standard convention where cylinder 1 is located at the front of the engine on the driver's side. This applies to the V6 engine configuration, where the cylinders are numbered from front to back. If the engine is a 4-cylinder, cylinder 1 is still at the front, but on the passenger side. Always consult the vehicle's service manual for specific details related to your engine type.
There is no clutch cable in 93 Mercury Capri. Its operated by hydraulics. There is a clutch slave cylinder and master cylinder. the seal in it probably worn out. Not very hard to work with.
The spark plug gap for a 1993 Mercury Capri 1.6 L - DOHC - 4 cylinder engine is : ( .044 inch )
it is just above oil filter to the left
The 1991 Mercury Capri engine is not an interference engine
The firing order for the 1991 Mercury Capri 1.6 liter, 4-cylinder non-turbo engine is 1342. Ford Motor Company produced the Capri from 1970-1977, then from 1979-1986, and again from 1991-1994.
According to one of Fords websites : For the 1.6 liter / 98 cubic inch four cylinder engine in a 1991 Mercury Capri ( the spark plug gap is .044 inch )
To replace the oil pump on a 1991 Capri, first, ensure the engine is cool and disconnect the battery. Drain the engine oil, remove the oil pan, and then detach the oil pump from the engine block by unbolting it. Install the new oil pump by aligning it with the oil pump drive and securing it with bolts. Finally, reassemble the oil pan, refill the engine with oil, and reconnect the battery.
On a 1993 Mercury Capri with a 4-cylinder engine, the oil sending unit is typically located near the oil filter, on the engine block. It is usually threaded directly into the engine and can be accessed from underneath the vehicle. Be sure to consult the vehicle's service manual for specific details and to ensure proper identification and handling.
60,000 miles according to the Gates website ( the 1.6 liter , 4 cylinder , IS an interference engine )
would take alot of modes but it could be done. and not cheaply. may even have to streach the hood and the hole engine area a little to make it fit.