0
Easier than it sounds. Start with the 4 fasteners in the scuff pad on the top of the bumper.
Use a screwdriver or whatever to pry up the centre part of the fastener. It's just a pin, or call it a plug, that expands the bottom of the fastener to tighten it in the hole. When the pin is up about 3/8 of an inch the rest of the fastener should pry out easily. If not, pull the pin completly out.
Four more in the underside of the bumper, plus six in the wheelwells. When they are all out jiggle the bumper from both sides, then pull it straight back.
See, I told you it was easy.
What else can I help you with?
What other year rear bumper covers match with a 2001 Mitsubishi galant?
what other year mitsubishi galant rear bumper cover is compatable with a 2001 cover?
What is the piece that covers the end of the bumper and part of the fender called on a 2001 Nissan frontier?
Bumper cover or fascia.
How do you change a front bumper cover on 2001 Escape?
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
How do you replace the rear bumper cover on a 2001 Dodge Grand Caravan?
Very carefuly.
How do you replace bumper cover for Mitsubishi mirage 2001?
To replace the bumper cover on a 2001 Mitsubishi Mirage, start by removing any screws or bolts securing the bumper, typically located in the wheel wells and underneath the bumper. Carefully detach the clips and connectors for any lights or sensors. Once all fasteners are removed, gently pull the old bumper cover away from the vehicle and align the new cover in place, securing it with the original hardware. Finally, reconnect any lights or sensors and ensure everything is properly fitted before tightening all fasteners.
Where is the LDP on a Jeep Grand Cherokee 2001?
It's behind the rear bumper on the left side or drivers side. You have to pull the bumper cover off in order to get to it.
Why is my front bumper loose on my 2003 Saturn l200?
On a Saturn there are metal clips that hold the bumper to the fender. One of these fell off of my 2001 SL1. It was fairly easy to replace, but should never have happened. It just simply clips in place once you line the bumper with the fender. I think these clips are in place all the way around the bumper. It was the passenger's side of mine that came off.
How do you remove the front license plate cover on a 2001 Aurora?
== == == == you don't it's molded int to the bumper.
How do you remove a rear 2001 jetta bumper cover?
To remove the rear bumper cover from a 2001 Volkswagen Jetta, start by opening the trunk and removing any plastic trim or covers that conceal the mounting bolts. Next, unscrew the bolts located on each side of the bumper, typically found near the tail lights, and any additional fasteners underneath the rear of the vehicle. Once all fasteners are removed, gently pull the bumper cover away from the body, being careful to disconnect any electrical connectors for lights if necessary. Finally, lift the bumper cover off and set it aside.
How do you change light cover 2001 windstar?
Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover
How do you remove the rear bumper cover on 2001 Lexus RX 300?
To remove the rear bumper cover on a 2001 Lexus RX 300, start by removing the screws and clips securing the bumper to the vehicle, usually found in the wheel wells and along the underside. Next, detach any electrical connectors for rear lights if applicable. Carefully pull the bumper away from the vehicle, ensuring not to damage any retaining clips. Finally, lift the bumper off the mounting points to completely remove it.
Where is the horn located on a 2001 Ford Taurus?
where the fender and bumper meet in the front on the drivers side behind the wheel well cover
