Jack up car, remove wheel, remove brake caliber. the rotor will pull right off
Remoce wheels Remove 2 caliper mounting bolts Slide caliper off rotor Remove rotor
you need to push down and back on the front of the bottom seat to remove the clips out of the brackets
To replace the front rotors on a 1994 Geo Tracker 4X4, begin by safely lifting the vehicle and removing the front wheels. Next, remove the caliper by unbolting it from the bracket, and hang it securely to avoid stressing the brake line. Afterward, remove the caliper bracket and then the old rotor, which may require some gentle tapping if it's stuck. Install the new rotor, reattach the caliper bracket and caliper, and finally, reinstall the wheels before lowering the vehicle.
It's threaded into the front of your exhaust manifold.
Remove the fuel tank then the gauge and pump.
Removing the crank pulley requires an impact wrench
To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.
Remove it an drop it into a pan of boiling water to see if it opens
The water pump on a Geo Storm is typically located at the front of the engine, near the timing belt or chain. To access it, you may need to remove the engine cover and other components, depending on the specific model and configuration. It's always best to consult a repair manual for detailed instructions and diagrams specific to your vehicle.
Remove the unit from the column and take it to a locksmith and have it re-keyed.
to remove brake rotors you will need to remove the hub assembly. you will need a slide hammer. unless you have this tool and lots of patience i would recommend letting a mechanic work on it.
To remove the ignition switch on a 1991 Geo Storm, first, disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing the fasteners, exposing the ignition switch. Disconnect the wiring harness from the switch and remove the screws securing the ignition switch in place. Finally, gently pull the ignition switch out from the steering column.