The thickness of the front rotors on a 2000 Ford Windstar typically measures around 1.0 inches (25.4 mm) when new. It's important to check the service manual for specific measurements, as rotors can wear over time. Minimum thickness specifications for replacement are generally around 0.9 inches (22.9 mm), but always refer to manufacturer guidelines for accurate figures.
That measurement is stamped on the rotor.
According to the 2000 Ford Windstar Owner Guide : The front park / turn lamps take the ( 3157 NAK , amber bulb )
The ABS sensor is located in the front brake set up. It is accessible by removing the tire and the caliper bolt, caliper, and rotor. It will be a black plug connected to a wire sitting on the top.
There are 2 wiper motors on a Windstar: 1 for the front wipers and 1 for the rear.
You can't - well, you can.. but the front bumper cover and the grill are all one piece
firewall 1-----2-----3 4-----5-----6 front of Ford Windstar
If you pull one of the front wheels the minimum thickness should be stamped or molded into the brake rotor near the hub area. I own a 2000 CR-V and the minimum thickness on mine shows as 18 millimeters.
the front or rear seal on the timing chain side
For our 2000 ford windstar it's $210 for all four.
On a 2000 Ford Windstar , 3.8 liter V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
where is the tcm in a windstar 2000 located