0
What is wrong when the clutch pedal stays at the bottom of the floor it doesn't come up?
One of two possibilities. Check the master clutch cylinder container to see if the fluid has all leaked out. If it has, chances are, either the master or slave cylinder need to be replaced. A mechanic fixed mine and wrote on the repair workup that he replaced the master clutch cylinder, however upon subsequent investigation, I discovered he had actually replaced the slave cylinder, refilled with DOT fluid and rebled the cylinder. This fixed the problem you described for me, on a 97 Honda Accord.
I just fixed a 2003 Accord and I'm fairly sure all Hondas use
hydraulic clutches. When you stepped on the clutch you
could see the clutch lever depress fully and then would
slowly move back as the pressure bleed off.
I replaced the slave cylinder first (it is easy
to get too) and that improved it little but then had to replace
the master cylinder to reallly fix it. Usually slave cylinders fail first
because the operate at much higher pressure than the master.
It really helps to have a pressurized bleeder because the line from
the master to the slave goes up and across the back of the engine
(I think I bought mine of Ebay) It make bleeding all hydraulic
systems a one man, fool proof job.
Also some mechanics have had bad results with nonHonda
parts.
Answer 2The above answerer is correct. However, another problem that can cause a clutch pedal to stay down is that your clutch is burned out. It happened to me when I had a Nissan 300zx clutch that burned out. Two days prior I was driving and the pedal just sunk to the floor but there was still some clutch left. After that the clutch just would not disengage anymore and I had to get it fixed.Before replacing ANYTHING you should bleed the clutch system. that is what was wrong with mine.
Hydraulic or Cable?The above answers may be correct but they assume you have a hydraulic clutch. There are two types of clutch assemblies, the hydraulic clutch aseembly and a cable clutch assembly, if you have a cable clutch assembly it may be as easy as replacing the clutch cable. Mine recently broke, it made a loud pop when I tried to shift into gear, when I took my foot off the pedal it just laid on the floor. I have yet to figure out how to replace it though, it is a European spec Volvo with very little info on it on the internet.
What else can I help you with?
2005 Sunfire clutch is stuck to the floor?
Well, we need lots more information here. Is the clutch pedal actually "stuck" to the floor? In other words, can you NOT lift the pedal up to the normal position? OR, has the clutch pedal "fallen" to the floor due to no resistance from the clutch?
Why does your clutch pedal touch the floor?
It's called: Your clutch is working.
Why does my clutch pedal go straight to the floor and stays down with no pressure?
You have a broken clutch.
Does a heavy truck clutch need to be adjusted when it release at the top or the bottom?
Any clutch that starts to move the vehicle at or near the top of the pedal movement (farthest away from the floor) needs to be adjusted.
Rover mg zt clutch pedal gone to the floor?
The clutch cable has proabably broken.
How can a adjust the clutch pedal on my 1993 Chevy s10 pickup to make it disengage the clutch closer to the floor?
where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.
How do you adjust the clutch on a 2008 Chrysler pt cruiser?
depress the clutch pedal to the floor several times
How to Adjust clutch pedal height peugeot 307?
To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.
Would the clutch pedal going to the floor and staying on the floor be just the clutch going out or what could it be if so and how do you replace the clutch on a 2001 Maxima?
You should not attempt to replace the clutch yourself unless you have considerable mechanical skills. In this case, the problem is most likely that the spring holding the clutch pedal in place is broken.
Can't change gear in ford vista and clutch pedal down to floor?
You may need a new clutch.
Brake fluid is running down the clutch pedal and when you mash the pedal the pedal remains on the floor?
Actually if the fluid is coming down the clutch pedal it is probably your clutch master cylinder going bad or the seal around it. No worries it is a cheap fix. If it is coming down the clutch pedal it has nothing to do with your brakes. Some people well most use brake fluid for the clutch.
Why doesnt Clutch disengage when pedal is depressed on my 1970 VW bettle?
Clutch plates are sticking - get your clutch checked you might need a new one
