0
What else can I help you with?
Turn signals on your 1994 Pontiac grand prix come on but do not flash .flasher has already been replaced?
Check bulbs could be bad switch in steering column
Turn signals on subaru impreza have stopped working checked all fuse plus relays .can anyone help cheers?
check if reverse lights are working, if not replace the reverse switch plug located underside near the gear box, centre of car, there are two plugs, check if wires are frayed, this happened to me and when I replaced this my turn signals started working. hope this helps
What could be wrong if your turn signals do not work but your hazard lights work?
Most vehicles have two flasher units. One for the turn signals and one for the hazards. If you have already replaced one try looking for the other one. Or check for a bad trunsignal switch
Already replaced Isuzu flasher unit with new one - hazards work but turn signals do not - both sides?
u have two flashers on your car... one for blinkers and one for flashers.
Transistors replaced to amplify electric signals?
vacuum tubes
Why do your hazard light works but turn signals do not in a 2001 ford ranger already replaced flasher?
It should be the fuse, in the fuse box at the Driver Side, check for the number 10 Fuse (7.5 Amp) it might be blown
What is the analogy for speaker?
A speaker is like a microphone in reverse. Instead of converting sound into electrical signals like a microphone does, a speaker converts electrical signals into sound waves that can be heard.
1999 Jeep GC that the turn signals and hazards do not work Headlights and interior lights are ok and have replaced turn signal lever already any advise?
Most obvious thing to check would be the flasher relay located under the bonnet
How do you remove turn signals and side markers on an 09 jeep wrangler?
let the wife reverse park in to a small space
Why don't my turn signals flash. Already changed the flasher?
check you light bulbs
Why are Hazards working but indicators not flashing on Audi tt?
It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
What causes the turn signal fuse to keep blowing on a 2004 Honda Element?
It might be that one of the dual filament light bulbs in the system have had the 2 filaments short out with each other. Usually this also causes problems with the stop signals,and turn signals also. I had this happen on a car a long time ago,after I had already replaced the switch. Always check the bulbs first.
