answersLogoWhite

0


Best Answer

You have a bad fuel pump or the wiring to the pump is shorted to ground somewhere.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would the fuel pump fuse keep blowing on a 1986 Chevy S-10 2.8 V6?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pump relay on 1986 Chevy El Camino 4.3 tbi?

The fuel pump relay on 1986 Chevy Elcamino 4.3 TBI is in the Fuel Injection Tank.


Wiring diagram on 1986 Chevy Silverado dual fuel tanks?

I need the wiring diagram on a 1986 Chevy silver ado dual fuel tanks


What causes an ECM fuse to keep blowing on a 1987 Chevy Blazer?

The fuel pump is shorting out and that is why the ecm fuse is blowing .Disconnect the the fuel pump and try it again,if the fuse blow's again then it is not the fuel pump.


Was the 98 Chevy 5.7 fuel injected or carb?

It is fuel injected. Chevy quite using carburetors in late 1986. from there on everything is fuel injected.


Where is the fuel filter located on a 1986 Chevy Blazer?

On the fuel line going to the carburetor.


How and where do you check the fuel pump relay on a 1986 Chevy Corvette?

== ==


Do you have to unplug the brown wire on a 1986 Chevy Pickup when setting the timing?

1986 should be carburatored and it is not required. That would only apply to a fuel injected engine.


When did Chevy 5.7l switch from carb to fuel injected?

late 1986.


Did 1986 Chevy truck have fuel injection?

no it had a computer controled quadajet


Where is the fuel filter located on a 1986 Chevy G20 conversion van?

The fuel filter for a 1986 Chevy G20 should be mounted on the frame under the van. The filter is an inline type and should be easy to change.


Chevy trailblazer 2004 air vents do not blow air?

If the air vents of the Chevy trailblazer 2004 are not blowing air, have the fuel pump checked.


Why does fuel pump fuse keep blowing in your 1992 Chevy Blazer?

My first thought is that the fuel pump is going bad and is drawing too many amps, second would be a wire grounding against metal.