If one of the wires is green and the other is black, the black one goes to the negative side of the coil and the green one feeds the tachometer.
It will have a black cap on it with 4 wires coming out and each wire going to a spark plug. Follow the wires from the spark plugs backward and you will find the distributor.
The two wires coming from an ACCEL distributor typically connect to the coil. One wire is for the ignition power source, while the other wire is for the tachometer. It's important to consult the manufacturer's instructions or a wiring diagram to ensure proper connection.
start by removing one wire at a time. Replace it with the closest length matching wire. Do this one wire at a time. What ever you do, don't pull all the spark plug wires at once. You might not install the wires in the correct order. good luck.
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.
A distributor cap holds all the wires, A coil only has 1 wire in the top of it.
The distributors have the wire numbers stamped on top. When I changed mine, I happened to clean the crud off, and there they were.
To correctly place the distributor wires on a 1992 Mazda 323, start by identifying the firing order, which is 1-3-4-2. Connect the spark plug wire for cylinder 1 to the distributor cap terminal marked for cylinder 1, followed by cylinder 3, then 4, and finally 2, ensuring each wire is securely attached. The distributor rotates counterclockwise, so maintain that direction while connecting the wires. Always verify the connections against the vehicle's service manual for accuracy.
Distributor has a center conductor that links to the coil via a wire the same size as your spark plug wires..
there are four spark plug wires that run to the distributor..the fifth one is the coil wire
2.0 lt 4 cyl, the distributor is square and the wires come numbered like this3 2this is the correct order for the wires from the distributor to sparkplugs4 1sp1 sp2 sp3 sp41 goes to the very left spark plug as shown above2 to the right of # 13 to the right of #24 to the right of #3
Look at the spark plugs-- if one has no wire at the top, that is the problem- there should be a wire from each spark plug to the distributor cap.
get a set of new plug wires for it that are pre-cut for the car and then replace 1 wire at a time.