0
1987 Mazda b2000 that sometimes dies when you use the turn signal but starts back up after it dies?
Wiki User
∙ 16y ago
What it usually turns out to be is a faulty turn signal relay. In more rare instances, there is a short in the turn signal switch in the column. The column switch has tail, brake, and blinker lights wired into it. Good luck
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the correct way to wire the ignition coil on a 1986 Mazda B2000?
Chiltons Mazda trucks manual has the picture and explanation.
How do you remove the starter on a 1984 Mazda B-2000?
I changed my starter motor on my 1984 B2000 Pickup. Has to be done from underneath. Raise the front end - use jackstands. Remove the negative battery terminal. The holding bolts on the starter are difficult to reach and slow to remove but,with patience, can be done. Space around the motor is tight but with persistance, you can snake it out. Good Luck.
Where is the starter solenoid located on a Chevrolet S10 pickup truck?
Hello, I found the info you want but it is impossible for me to explain because I am learning about these trucks myself. I bought a 1984 B2000 workshop manual from Mazda for around $17.00 and it has full instruction for everything for your truck including a full teardown. The information you want on Chapter 5: page 10 It has full pictures and exploded view of starting motor and solenoid. I wish I could be more of a help because I DO know the frustration. I am going through it myself with a part that I can't find what it does. I even put up a site to ask for help. http://nicknails.com/B2000/index.htm Good luck on your B2000 because if you can keep it running, it's a great little truck. Nick
Why am I not getting any spark from my coil even after replacing it with a brand new one on a 1986 B2000?
Turn key on. Check for power getting to coil. Check all wiring for good connections. If OK, your problerm is most likely in your ignition system. In other words, it's not telling your coil to fire so it's not.
How can you tell if the ignition switch is going bad in a 1987 Mazda B2000 SE-5?
The symptoms may be one of several things.One is when you start the truck the gauges may not like the fuel,water temp,and warning lights do not come on.Another issue as (I have had) start the truck gauges work,warning lights but,when I turn the fan on for air,or heat nothing and had to jiggle the key in the ignition and it came on.Also had to remove the main fuse it is the large black in the center of the fuse block and reinstall to make the fan work.The other possibility is delay of no start or nothing happening when the key is on and not due to the alternator,starter,or battery or bad grounds.Even the dome light,radio not working as another example with the key on or even the truck running but,no power to either items.If you need to replace it just remove the five screws on the steering column, and the key cylinder or ignition is accessable.When replacing disconnect the ground cable on the battery before you do this as not to cause any sparks,or blowing fuses or melting wiring.The average cost of a new ignition is around 130.00 by most auto stores like auto zone,advance autoparts.
Which Mazda cars can you flat tow?
mazda b2000
What is the engine oil capacity for an 1986 Mazda B2000?
The engine oil capacity for a 1986 Mazda B2000 is 4.1 quarts.
What carburetor is on a 1986 Mazda b2000?
I believe the carburetor is a Mikuni. I have a 1986 B2000 myself.
Is a 1988 Mazda B2000 a 4 cylinder?
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
Is a 1988 Mazda B2000 carburated?
Yes, all B2000 models until 89 where carbureted. After 89 Mazda stopped production in the United States on this model.
Where can I purchase auto parts to repair a Mazda B2000?
One could purchase auto parts to repair a Mazda B2000 from the Mazda B2000 Auto Parts online catalog. Other places to purchase auto parts to repair a B2000 would include O'Reilly Auto, Advance Auto Parts and also Auto Parts Wearhouse.
When changing the oil on a 1986 Mazda B2000 How many quarts do you put in?
4 quarts. I own a 1986 B2000.
What is the firing order for a 1986 Mazda B2000?
firing order is 1, 3, 4, 2 for a 86' B2000
Where is tank fuel gauge for 1986 Mazda pick up B2000?
where is fuel gauge and how to replaced for a 1986 Mazda pick up B2000 please let me know thank you
Where can you find a Bed cap for 1986 Mazda b2000?
As of 2014, there are a few places where you can find a bed cap for a 1986 Mazda B2000. This part can be found at local body shops and auto part stores and through Mazda.
What are the valve lash specs of a 1986 Mazda B2000?
0.012
What is the oil capacity of a Mazda B2000 truck?
about 4 qts
