only one sensor on the rear axle housing just replaced mine but check engine light comes on for same thing even after electronically clearing the code and turning off engine light only takes 50 feet for it to come back on and i cant figure it out Could also be a broken wire between the abs computer and the rear axle speed sensor.
All you need to do is replace the sensor. It cost around $20.
The Dodge Neon does not have a MAF (Mass Air Flow) Sensor. It does, however, have a MAP (Mass Air Pressure) sensor located on the intake manifold between the two left runners.
If you know it is bad, just unbolt the hold down and pull it out.
It is under the housing where the lower hose attaches to the block. The new thermostat should have the seal with it, and that should be all you need.
It is called a APPS accelerator pedal position sensor. It is located on the front of the engine. It is the part that the throttle cables hook to.
where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan
Rear camshaft seal bad. Replace. located behind cam sensor.
I should be just above the brake pedal where the shaft of the pedal pushes up against the switch. It should be easy to adjust or replace
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
how to replace a map sensor on a 2004 dodge intrepid.
A 2000 Dodge Neon does not have a maf sensor.
how do you replace a cam shaft sensor in a 2002 3.3L dodge grand caravan
they should be right before and after the catalytic converter
where is the crankshaft sensor located on a 1993 dodge intrepid
The sensor is located inside the distribuitor
where is the engine speed sensor located on a 1999 dodge stratus 2.4 l
it is a throttle position sensor, should be located on the rubber part that goes to your air filter box.