that depends on what car you are working on
Yes you can.
If this is a 4-cyl, it is a very in-depth process to replace the seal...removing motor mounts and the majority of engine components to be able to pull the camshaft. If it is necessary, follow instructions for replacing the head gasket on your model. You can replace the seal at the point of removing the Timing Belt.
no
if your talking about when your cranking the engine over with the cap off, then you have a broken distributor gear or shaft or bad camshaft gear.
Yes, the camshaft position is critical for both compression and ignition reference. That is valve timing. But there is no code to tell you your valve timing is off. There is a Camshaft Position Sensor, check for voltage at the connector, broken wiring or corrosion and then ohm out or replace the sensor. Get e repair manual and learn about your car, you'll save money, I promise...
A camshaft seal keeps engine oil in and dirt/water out.
Rear camshaft seal bad. Replace. located behind cam sensor.
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin
NO. If the camshaft is broken it will not run. If the camshaft is worn it will run poorly.
Camshaft sensor is going bad. I've had to replace two now.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Replace the camshaft sensor
no
the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it
yes
It is important to recognize when poor performance is due to a bad car part. Symptoms of a bad camshaft sensor are misfiring, hesitation during acceleration, and not starting.
It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.