0
Can you replace belt on 3.1 v6 without putting ac compressor back on?
Wiki User
∙ 14y ago
Most of the time, there is no way to route the belt without all the pulleys in place. As long as the bearing in the clutch on the AC turns it is alright, the compressor itself does not need to work.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace air conditioning compressor on a 1987 Fiero?
Reclaim the freon from the 1987 Fiero. Remove the ac belt, then disconnect the lines from the compressor. Unbolt the compressor then bolt in the new one. Put the hoses and belt back on, then pull a vacuum on the system before filling with new freon.
How do you safely remove a movano airbag to change the wheel?
Disconnect the battery. It cannot blow without the battery. Same when putting it back. Make the electrical connections and install the airbag then reconnect the battery.
Put back seat in 2002 Saturn L200?
How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it. How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it.
Where in the engine bay is the AC compressor located on a 1995 Chevy Monte Carlo?
What engine? Find the serpentine belt. One of those pullies is the ac compressor. Check for a couple of aluminum lines going the back of one of those components as well as and electrical plug and you found it.
How do you replace the alternator on a 1998 Chevy Malibu LS?
There are two bolts one is visible on the front and one on the rear. There is a nut on the right side next to the ground on the alternator. once it, the ground, and the molex plug are removed it pops right out. One key thing to remember when putting it back on is to be sure to put the belt on before you put the bolts back in, or you have to mess with the tension pulley.
How do you replace the air compressor on a 1989 Chevy Cavalier Z24 with a 2.8L engine?
There are three 13mm bolts on the front of the compressor and one 10mm bolt on the back. the rest is recovering the froen, taking the lines off, there is a plug on the back of the compressor.
How do you replace an Air compressor gasket?
There are many gaskets on any machine. Is this an electric compressor? Once you find what gasket it is specifically, you simply need to remove that part, and add a new gasket, then put the part back on...
How do you replace an ac compressor on a 96 aurora?
Reclaim the freon as it is illegal to let it into the atmosphere. Take the drive belt for the compressor off, then remove the lines. Unbolt the compressor and swap it with the new one. Connect the lines back with new o rings. Put the belt back on. The system will need a vacuum pull before it can be filled with freon.
How do you replace the compressor clutch on 1990 f150?
go to autozone or discount and rent a removal tool, will not cost you just leave a deposit& you get your money back when finished with it , just remove bolt at end of compressor and tool does the rest
How do you replace air conditioning compressor on a 1987 Fiero?
Reclaim the freon from the 1987 Fiero. Remove the ac belt, then disconnect the lines from the compressor. Unbolt the compressor then bolt in the new one. Put the hoses and belt back on, then pull a vacuum on the system before filling with new freon.
Can you just change the ac pulley on an 03 jeep liberty instead of the whole compressor?
Yeah, but it's a bugger, you'll need a special puller so you don't damage the compressor, and getting the new one back on is tough. It's why most people just replace the compressor.
Why have you had the compressor replaced three times in a 1991 Honda Prelude?
You can't just replace the ac compressor itself... you have to replace several parts of the system... any auto parts store should tell you that when you buy one especially if you have been back three times.... usually there is stuff in the lines still that gets pulled into the new compressor and voila you're stuck with the same problem you began with.
A compressor that has a piston that travels back and forth in a cylinder is a?
It is simply a piston compressor.
How often should you replace your pillow?
I've heard you should replace your pillow when you can bend it in half without it bending back.
How do you replace an ac compressor on 1984 Chevy Celebrity?
To change out the ac compressor on your 1984 Chevy Celebrity: 1. If there is any freon or pressure left in the system you should have a professional empty the system. 2. Remove the hose off of the back of the compressor. Plug the openings to keep dirt out. 3. Loosen the adjusting bolt and slide the compressor over and remove the drive belt. 4. Remove the bolts and the compressor will come out. Reverse the procedure to reinstall the compressor unit.
Where do you find a diagram and instructions to replace an ac compressor in a 1997 Geo Prism?
Recommend have a/c specialist replace compressor because system should be at the very least "evacuated" after compressor change to remove any contaminents in system. Thanks for your comments and advise. I have already had the system professionally evacuated, but they want a fortune to exchange the compressor to tune of $800.00 and I did get different estimates. My car takes R-134 which I can put in myself. Back in the 60's thru the 80's I used to replace the compressors and refrigerant until they disallowed that. I just need to know where the hidden bolt(s) are.
Already changed fuse and air conditioning compressor clutch assembly but no power going to cause the compressor to kick on to pull back the clutch so that compressor kicks on what could be the cause?
What specific kind of vehicle do you have? It does sound like the clutch may be bad, but we also need to know what you are working on. You need to run power straight from the battery to the compressor. If is still does not engage then you need to replace the compressor and clutch, they are dead. If they do engage, then you have a wiring or computer issue.
