answersLogoWhite

0

Every part of the computer control and injection system needs to be considered. For example, the fuel pump of an injected system runs at a much higher pressure than a carburated system. You'll need to work that out. You would need to work around the electronics for the ignition if you decide to use a HEI system and you'd probably need to do some rewiring of the keyswitch circuit as well as possibly some modifications to the gauges. Understand that most injector fuel pumps are also connected to the fuel gauge system. Whatever you THINK you've worked out, there will be additional concerns. But it can certainly be done. Converting the engine will probably be the easy part.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the ignition module on a 1994 Eagle Summit?

Integrated into distributor, under the rotor cap which is completely sealed and not replacable. Unfortunately you have to purchase an entire distributor.


Is a coil pack and distributor the same thing?

Coil packs are analogous to the old distributor systems. Most modern cars do not use distributors anymore. Instead the ignition systems are completely electronic.


How do you change the distributor on a 1994 Chevy Caprice Classic?

All 1994-96 vehicles, use a new distributor ignition system which was originally developed for use on Corvette. The new system known as the Opti-Spark ignition system consists of a distributor assembly which is mounted on the front engine cover, under the water pump assembly, control circuitry an external coil. I the Opti-Spark system, all ignition timing is controlled by the PCM based on signals from the distributor


How do you replace the ignition distributor on a 93 mx6 v6?

How do you replace the ignition distributor on a 93 mx6 v6 pics?


How do you wire a prestolite distributor?

To wire a Prestolite distributor, first ensure the ignition is off and the battery is disconnected. Connect the primary ignition wire from the ignition coil to the terminal marked "B" on the distributor. Then, connect the secondary wire from the distributor cap to the ignition coil's output terminal. Finally, ensure that all connections are secure and that the distributor is properly grounded before reconnecting the battery and testing the ignition system.


Where is the ignition condenser at on a hei ignition system?

inside the distributor


Does a 96 cavalier have a distributor cap?

Yes, a 1996 Chevrolet Cavalier does have a distributor cap, as it is equipped with a traditional ignition system. The distributor cap is part of the ignition system, which helps to route high voltage from the ignition coil to the correct cylinder. However, some later models may have transitioned to distributor-less ignition systems (DIS), which do not use a distributor cap.


Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.


Chevy 327 electronic ignition module replacement?

The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.


Where is the ignition coil on a 96 civic cx hatchback?

The ignition coil is inside the ignition distributor.


Find distributor on 5.4 motor?

No distributor , Coil On Plug ( C.O.P. ) ignition system


Why does the spark plugs not get spark but the distributor gets power on a 1992 jetta?

Bad ignition rotor? Bad distributor cap? Bad ignition wires?