answersLogoWhite

0


Best Answer

the cold air intake changed your Mass Air Flow size, and your car will see, obviously, massive decreases in performance until it's fuel/air ratio is changed to accommodate the much leaner mixture. your car is tuned for the stock MAF, and that's why the stock one works fine. you have two options- 1. is buy another cold air intake with the same MAF size, or 2. take it in to get adjusted. once one of these happens, you should see an increase of about 10rwhp. so- I'd just get it tuned- after the fact, it'll still be cheaper.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do i need to reset my computer after installing a cold air intake for my '91 mustang its idleing and starting horribly after i installed the CAI. but seems fine once i put the stock intake back on.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When starting a computer a customer can no longer select two of the operating systems that are installed Which file may be corrupted and causing this error?

Boot.ini


What is a problem with computer hardware?

A common problem with computer hardware involves the drivers. Many people will install new hardware (video card, sound card, network card, card readers, web cams) without installing the proper drivers. A driver tells windows how to use the hardware, and where it located, when not installed windows will not be able to use the newly added hardware, and may give many alerts on starting windows.


After installing a fuel filter in a 1997 Mazda 626 LX what is the procedure for starting the car if it cranks but sounds as if it is not getting fuel?

Could the new fuel filter be installed backwards, therefore shutting off the fuel supply?


You just installed a starter in to your jeep after starting it you noticed a noise you shut down the jeep and the starter was still going?

Remove the faulty new starter and replace it again. you know get another one. assuming you were correctly installing it.


Electronic instructions that the computer hardware uses?

When a computer starts up it needs to check various things that may stop the computer from starting properly. These instructions are contained in the micro-processor that is installed as part of the computer. These instructions are long, detailed, and what most people normally do not worry about


What is booting of computer?

The booting of a computer is the re-starting of a computer


Can you replace a battery on a 1997 Jetta without messing up computer and causing it not to start?

Yes Of Course. When Replacing Any Battery Remove The Negative Cable First, Then The Positive. Then Installing The New Battery Install The Positive Cable First Then The Negative. Dear reader; Many computer equiped autos have no protection against damage if the battery is installed backwards. Some have fuses in critical circuits which offer some protection. Jump starting can also cause these fuses to fail. Dwight


When installing new software placing the CD into the CD drive will usually cause the to automatically start?

Automatically Start what installing?? or Just a Window for starting Installation?


Why is majora's mask not starting when i have a jumper pak installed?

not connected


What is the term for starting a computer?

Its also termed as booting a computer


What sentence has all the words starting with 'i'?

In Iceland insulation is invariably installed in igloos.


What turns on a computer?

turning on the computer, starting the computer, startup, or booting up the computer