1) If fuel tank is full you will need to siphon fuel out 2) Remove any type of skid plate or cover from fuel tank. 3) Disconnect fuel fill tube, wiring harness, and fuel lines from fuel tank. 4) Support fuel tank and remove hold down bolts(or nuts) for fuel tank strap. 5) Lower fuel tank to ground. NOTE: You may need to remove driveline on some vehicles to have room to get tank out. 6) Use brass punch to unscrew fuel pump locking plate on top of fuel tank. 7)Remove and replace fuel pump from tank and reassemble everything the same way you took it apart.
Replace the coolant temp sensor.
A faulty fuel pump will make a 1996 Chevy Tahoe hard to start after it sets for a few hours. The pump can allow fuel to leak back into the gas tank and starve the engine for fuel.
The fuel pump for the 1990 full size blazer is located inside of the fuel tank. If this model does not have an access plate in the floor of the blazer then the tank will have to be removed to get to the pump.
You cant unless you have access to a factory service manual that gives you the pin tests to test the ohm and voltage loads through it. Just replace it if you think it is bad. THen you have no question. Usually they are less than ten bucks. Usually.
The fuel pump relay on that 92 Blazer with the 4.3 engine is located under the hood, on the firewall, drivers side, if there is more than one relay there, it's the one closest to the drivers fender.
How do you replace fuel injectors on 2003 Chevy blazer?Read more: How_do_you_replace_fuel_injectors_on_2003_Chevy_blazer
Where is the location of fuel pump relay on 1996 Chevy Blazer?
small evap leak, check the fuel cap, if it is not loose, replace it.
16 gal
Remove the fuel tank for access
pull the gas tank out and replace it
No, You will have to remove the fuel tank.
Does it turn over? Compression, Fuel, Spark?
Drop the tank, it is inside of it.
Yes you do , It is inside the fuel tank
because you suck it until it hurts
under the drivers side on the frame