Remove driveshaft. Remove transfer case if you have 4X drive. Support engine. Remove transmission. Replace clutch. Reverse procedure to install.
This is a big job and you will need a good step by step manual.
Read this:
http://free-auto-repair-advice.blogspot.com/2007/11/finding-repair-information-you-need-at.html
It is best to get s shop manual on your car as it is a big job. The parts store should have one.
Unless you are very well versed in mechanics and have a lift and holding fixtures for the engine, take it to the garage.
The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Should cost 400-600 in labour 300 for the part.
The front wheels on a 1994 Ford Ranger lean inward due to the camber of the steering alignment. Adjustments can be made at a local tire shop.
underneth the intake underneth the intake
it is a manual 5 speed tranny.
Should be on firewall next to master cylinder
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
changing clutch in 1994 ford ranger ===================================================================== If it is like the ( 1996 ) Ford Ranger The clutch fluid reservoir is in the engine compartment , it is between the Power Distribution Box and the drivers side fender , It takes DOT 3 brake fluid
Not if it is working alright. however if you suspect its the worst for wear it would be a good idea,
how to i change a clutch in a 1993 ford ranger
The hydraulic clutch slave cylinder is inside the manual transmission bellhousing
how do I bleed the clutch system in a 2004 ford ranger
yes
You're gonna hafta drop the entire tranny to get to the clutch, pressure plate, and even tho throwout bearing/ slave cylinder.
get a book! you have to drop the transmission which isn't a whole lot of fun then unbolt the old clutch assembly and install a new one
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
you will need to remove either the engine or the transmission(engine is easiest in the 94 escorts) replace the clutch and put the engine back in