Lug bolts are normally hammered or drawn into place with the use of the wheel. They are removed the same. Remove the wheel, you may have to set the rotor in such a position that allows for the lug removal. Usually a very small gap allows for it. Take a good hammer and carefully pound it in till it pops out the back. Take your new one and push it in than tap it a few times till enough thread is showing that it can be drawn in all the way with the wheel installed.
Not aligning the threads up correctly and forcing the lug nut onto the wheel stud will strip the lug nut.
You may have to get a nut splitter, a grinder, or a hammer and chisel to get nut off and then have stud replaced. Hopefully the splines in the drum haven't been torn out and a new stud can be pressed in. If not, you might be running a lug nut short (which is not at all wise) or you'll have to come up with a new drum. Auto recyclers live for challenges like this.
100 Ft. lbs.
use a flat head screw driver.
my guess would be that odd one locks? so it prevents theft..
with the lug wrench!
A website named bransport.com carries lug nut removers for various size lug nut locks. It uses a reverse thread that tightens on the lug nut as you turn it counter clockwise to remove.
the lug nut adapter is located in the trunk with your jack, spare, and lug wrench, if you have taken it to a shop they may have put the adapter in your glove box, its about twice the size of a lug nut.
Put the key in the lug nut lock and keep turning it until the entire locking lug nut cover assembly comes off...just keep turning it clockwise with the key until the whole thing comes off. Then use the lug wrench to remove the lug nut that is holding on the spare tire cover. Remove the cover and then take the other lug nuts off.
Remove the plastic lug nut cover with a screwdriver. Use the lug nut key to unlock the one special lug nut per wheel. Usually found in the glove box.
In Mr. Tire, $65.00 up.
To change a flat tire on a 2006 Toyota Matrix with a special lug nut, first, ensure the vehicle is on a flat surface and engage the parking brake. Use the lug nut key to loosen and remove the special lug nut, then lift the vehicle with a jack and remove the flat tire. Replace it with the spare tire, tightening the lug nut securely before lowering the vehicle back to the ground. Finally, double-check that all lug nuts are tightened properly.
It requires a special "key" to remove that nut.
no you can't in any state it can't be missing
Yes, jack the car up and remove the lug nut to remove the hub cap.
The lug nut size for a 240sx with a four lug pattern is 10x1.25. The lug nut size is 12x1,25
The Honda CR-V lug nut size is a 19 mm lug nut. The 2000-2002 size was a 21mm lug nut.