1992 Chevrolet Blazer bulb replacement: Purchase the correct replacement bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
The fuel pump for the 1990 full size blazer is located inside of the fuel tank. If this model does not have an access plate in the floor of the blazer then the tank will have to be removed to get to the pump.
it means get your brakes fixed xD
Easy one.Warm engine to full operating temperature.Loosen, slightly 4 bolts from water pump pulley (smooth at the top, towards the fron of the car).Remove serpentine belt.Remove 4 pulley bolts.Drain radiator.Remove 5 water pump bolts and thoroughly clean any old gasket.Reverse procedure to install.
you pull out the radio and dash cluster and you will have full access to the ignition just turn it over and un clip the wires
Air trapped in the cooling system. Be sure the coolant reservoir is full to the max line and replace the radiator cap, it has a faulty check valve.
Yes you do. There is no other way.
YES, There the same.
yes but you would have to replace drive shafts. The 4x4 shaft is shorter due to the transfer case.
700r4
if its a full size blazer 7000lbs
yes it will
a full size blazer top weighes about 250 to 300 lbs
Aprox 12 qts.
4L60E.
I may know the answer if it is a full size Blazer. There is a ground wire for the socket that may be connected to an area that has rusted and no longer is grounded. Reconnect to a solid piece of metal for the light to work.
The spark plug gap for a 1994 full size Chevy Blazer with a 5.7 liter engine is .045 inches. This is equal to 1.1 mm.
Broken cable?