I had this happen on my 1974 Dodge Dart swinger. A mopar guru gave me this tip and it worked like a charm. The internal contacts for the nobs after so many years build up dirt and reduce or completely restrict the flow of current. To clean them you have to completely remove the instrument panel, Not fun, and then youl have access to the internal workings of your dash light nob. All you need is some sand paper and you can clean those contacts up so there as good as new. I had been driving without my dash lights for at least two years till I heard about this trick from the mopar guru. Now my dash lights work great.
no, the dart was never a twister model but the dodge demon made that model in 1971.
The switch is located on the steering column right before it exits the cab.
The lock is accessible by removing the steering wheel and the signal switch underneath. You have to depress the spring loaded catch that is visible from above with the tip of a flat blade screwdriver and it will pop out.
yes you should be able to make it fit.
right above the dampener.
I believe the hazard switch is used as the turn signal flasher in 71 bus. No extra flasher involved... I believe the hazard switch is used as the turn signal flasher in 71 bus. No extra flasher involved...
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
you have to jack up the engine one side at a time and replace them.
The bentley manual "green book" has all the wiring diagrams you need.
29,460 were built in 1971
yes
Dodge Ram Van was created in 1971.
Frances Dodge died on 1971-01-24.
The Dodge Dancing Party - 1955 1971-09-04 was released on: USA: 4 September 1971
Unplug harness from back, depress pin on unit to release pull lever, unscrew nut and it comes off.
318 in my 1971 Dodge Charger Special Edition
2,165 convertibles were built in 1971